Tenda 4G09 Router All for Better NetWorking User Guide
- June 5, 2024
- Tenda
Table of Contents
Tenda 4G09 Router All for Better NetWorking
Set up the router
- Attach the antennas to the router,
- Insert a Mini SIM card into the slot on the bottom panel of the router.
- Use the included power adapter to connect the PWR jackof the router to a power source.
- Press the ON/OFF button down to tum on the router. Walt for a few seconds, the router Is successfully connected to the Internet, when the following indicators light up.
NOTE: If the .fJ indiCiltor does not light up, refer to 01 in FAQ to find a solution.
Customize your network
- Connect your computer to the WAN/LAN or LAN port of the router using an Ethernet cable, or connect your smart phone to the Wi-Fi network of the router using the WI-Fi Name labeled on the bottom panel of the router. There is no Wi-Fi password by default.
- Start a web browser and visit tendawifi.com.
- Follow the Quick Setup Wizard to customize yourWi-Fi network.
LED indicators
| LED indicator | Status | Description |
|---|---|---|
| Solid on | The router ;s powered on prope,ly, | |
| m, | The router is powered oil or no, powered on properly. | |
| Solid on | The route,is connected to theinternet. | |
| m, | No internet acce-ss is available. | |
| Solid on | TheWi-Fi network is enabled. | |
| Blinking | The router;, performing WPS negotiation | |
| m, | TheWi-Fi networkis disab led. | |
| Solid on | At least one iceisconnected toa LAN port of therouter. | |
| °” | No device isconnected to any LAN port of the router. | |
| 3 bars | Excellentsignal. | |
| ,l .ba,rs | Good sig nal. | |
| Fairsignal. | ||
| °” | No4G/3G sig nal. |
FAQ
Q1 :The [J LED indicator does not light up. What should I do?
A 1: Start a web browser, and access tendawifi.com to customize your network:
- If you are required to enter a PIN code to unlock the SIM card, contact your ISP for the PIN code.
- If you are required to enter APN parameters manually, enter these parameters provided by your ISP.
- If the [j LED indicator is still off after you finish the Quick Setup Wizard, your SIM card may run out of money.
If the problem persists, contact your ISP for help.
Q2: I cannot access the web UI of the router by visiting tendawifi,com.
What should I do?
A2: Try the following solutions.
If you log In with a wire less device:
- Ensure that your wireless device is connected to the Wi-Fi network of the router.
- Disable the cellular network of your wireless device.
- Clear the cache of your web browser or change another web browser and try again
If you log In with a wired device:
- Check if the computer is connected to the router properly.
- Check If your computer used to set up the router obtains an IP address of 192.1 68.0.X (X ranges from 2 to 254). Otherwise, connect your computer to the router again after disconnecting from the router.
- Clear the cache of your web browser or change another web browser and try again.
If the problem persists, reset the router and configure it again.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>