BOSS BHT3-R Garage Door Remote 3 Channel Button Instructions

BHT3-R Garage Door Remote 3 Channel Button
Instructions

Art.
BHT3-R

SPECIFICATIONS

Guardian Boss
Frequency – 433Mhz
Buttons – 3

Art.
M-BT See page 63 for programming instructions

COMPATIBLE WITH

Remote Programming Steps

Adding Remote Controls -Roller Door

1. Locate the receiver board (garage door motor) behind the face plate.
2. Press the ‘Learning’ button once (under the large aqua button). A Yellow LED will turn on.
3. Press any button on the new remote once and hold until the Green LED blinks twice.
4. Press the‘ Learning’ button again and the Yellow LED will turn off.

Adding Remote Controls – Overhead/Tilt Doors

1. With a pointed object push the ‘Radio Set Button’ on the receiver (garage door motor).
2. A courtesy light will turn on for 30 seconds.
3. Within 30 seconds push any button on your new remote until the courtesy light flashes twice.

Deleting Remote Controls – Roller Door

1. Turn off the receiver (garage door motor).
2. Press & hold the ‘Learning’ button and then turn the power on. Continue holding the ‘Learning’ button until you see 3lights flashing.

Deleting Remote Controls – Overhead/Tilt Doors

1. Hold the ‘Radio Set Button’ on the receiver (garage door motor) for 5 seconds.
2. Courtesy light will then flash 7 times.

Whilst every effort has been made to ensure the accuracy of the information supplied herein, we assume no liability for any errors or omissions. Information contained in this document is subject to change without prior notice.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>