DRAPER 08909 Safety Helmet Instruction Manual
- June 10, 2024
- DRAPER
Table of Contents
08909 Safety Helmet
Instruction Manual
SAFETY HELMET
| Stock Nos. | Part Nos.SH1 |
|---|---|
| 8906 | Yellow |
| 8908 | White |
| 8909 | Blue |
| 8910 | Orange |
| 8911 | Black |
SPECIFICATION AND MARKINGS
EN 397:2012+A1| The European Standard Number for Industrial Safety Helmets and
its year of publication
---|---
53-63 cm| The size range of the helmet, head circumference.
-209C/-30T| The helmet will provide some protection when worn in an environment at or above these temperatures.
440 Vac| The helmet will protect the user against short term, accidental
contact with live electrical conductors up to a voltage of 440 Vac (Volts a.c
).
LD| The helmet will provide some protection from lateral compressive loads.
FITTING AND ADJUSTMENT
For adequate protection this helmet must fit or be adjusted to the size of the
users head. The helmet must be worn with the peak facing forward. To atter the
fit, adjust the harness at the rear of the helmet and ensure a comfortable fit
is made around the crown of the head.
When not in use or during transportation, this helmet should be stored in a
container such that it is out of direct sunlight, away from chemicals and
abrasive substances and cannot be damaged by physical contact with hard
surfaces/items.
USAGE
The helmet is made to absorb the energy of an impact by partial destruction or
damage to the shell or harness and even though such damage may not be readily
apparent, any helmet subjected to severe impact should be replaced.
The attention of users is also drawn to the danger of modifying or removing
any of the original component parts of the helmet, other than as recommended
by the helmet manufacturer.
Helmets should not be adapted for the purpose of fitting attachments in any
way not recommended by the helmet manufacturer.
Accessories and/or replacement harnesses, chin straps, ear defenders, visors
and helmet mounted lamps are available with fitting instructions from JSP.
Do not apply paint, solvents, adhesives or self-adhesive labels, except in
accordance with the instructions from the helmet manufacturer.
INSPECTION AND CARE OF THE HELMET
The helmet is a complete system consisting of shell and harness.
The helmet’s useful life is affected by many factors including the cold, heat,
chemicals, sunlight and misuse.
The helmet should be examined daily for obvious signs of cracking, brittleness
or damage to either helmet or harness.
The date of manufacture is moulded into the peak of this helmet. While the
helmet is free from defects it is suitable for its intended purpose.
Under normal circumstances the helmet has a maximum life of 5yrs from date of
manufacture.
Under no circumstances must a component other than a JSP component be used on
a helmet.
The helmet may be cleaned with the use of soap and warm water and dried with a
soft cloth.
The helmet should not be cleaned with abrasive substances or solvents and must
not be stored in direct sunlight or in contact with any solvents.
**Helpline: +44 (0) 23 8049 4344
Sales Desk: +44 (0) 23 8049 4333
General Enquiries: +44 (0) 23 8026 6355
intemet: drapertools.com
email: sales@drapertools.com
Draper Tools Limited, Hursley Road
Chandler’s Ford, Eastleigh
Hampshire. S053 1YF UK. SRTL1021
**
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>