trevi HMP 12E40 ENC Bluetooth Wireless Earbuds User Guide

trevi HMP 12E40 ENC Bluetooth Wireless Earbuds

SIMPLIFIED EU DECLARATION OF CONFORMITY

Hereby TREVI Spa declares that the radio equipment type HMP 12E40 ENC is in compliance with directive 2014/53/EU.
The full text of the EU declaration of conformity: https://www.trevi.it/dms/zidi/TREVI/DOCHMP12E40ENC.pdf

WARNINGS AND USAGE NOTES

• The device shall not be exposed to dripping or splashing. No objects filled with liquids, such as vases, shall be placed on the unit.
• If liquids penetrate into the device immediately disconnect the mains plug from the socket and carry the device to the nearest authorized TREVI Service Centre.
• No naked flame source, such as lighted candles, should be placed on the unit.
• Keep the unit away from the following locations: near magnetic fields; near to heat sources {radiators, heat registers, direct sunlight, etc.); near wetlands (bathrooms, swimming pools, etc.); dusty areas; areas subject to strong vibrations.
• Instruct the proper use children and people with little knowledge of the product.
• Listen at high volumes for a long period of time, may damage your hearing.
• Voice messages are provided in English and cannot be changed.
• Keep the following user manuals.

To avoid possible hearing damage, limit the time listening at high volumes.

CARE AND MAINTENANCE

For cleaning we recommend using a soft, slightly damp cloth. Avoid solvents or abrasives.

WARNING

The good construction of this equipment ensures proper function for a long time. If however arise some inconvenience, you should consult your nearest Trevin authorized service centre.
TREVI follows a policy of continuous research and development, so the products can have different characteristics than those described.

PACKAGE CONTENTS

The pack contains:

• Earphones
• Charging box
• USB/USB Type-C cable

EARPHONES OVERVIEW

1. Touch control
2. Speakers
3. Charging contacts
4. LED indicators of the charging base
5. Type-C charging socket

BATTERY INFORMATION

The earphones are equipped with an integrated lithium battery and, with fully charged battery, have a range of about 4 hours of music listening. The first time you use earphones make a full charge.
The full performance of a new battery is not achieved until after two or three complete charging-discharging cycles.

Note:
The battery lifetime may vary depending an the mobile phones or other compatible Bluetooth • devices and the settings of styles and usage environments.
The battery cannot be replaced, so do not try to remove it by opening the device and risking damage thereto.

CHARGING VIA CHARGING BOX

Recharge before the charging box, like this:

1. Connect the USB socket of the supplied USB/USB Type-C cable to a device equipped with a USB socket (computer, tablet) or to a power adapter (not supplied) supplied with a SV = USB socket;
2. Connect the USB Type-C socket of the supplied USB/USB Type-C cable to the USB Type-C socket of the charging cradle (5); during the charging phase, the LED indicators of the charging base (4) will show the percentage of charge. Full battery charging time varies depending on the charge source used;
3. At the end of the charge, disconnect the source from the charging base.

Once the charging box is charged, proceed with the recharge the earphones, like below:

1. Insert the earphones into the slot inside the charging cradle; make sure that the charging contacts (3) match;
2. Charging will start automatically; during this phase, the LED indicators on the charging cradle (4) will turn green and the LED indicators on the earbuds will be red. When charging is finished all LED indicators will turn off.

INDICATION OF BATTERY LOW

When the battery is about to run out, the earphones will emit a sound message and the indicator LEDs will flash red.

TURNING ON /OFF THE EARPHONES

Auto Power On/Off

The earphones will turn on automatically after removing them from the charging cradle and will turn off automatically once stored, and finished charging.

Manual power on/off

Press and hold the Touch Multifunction Keys (1) on both earphones for 2 seconds to turn them on.

Press and hold the Touch Multifunction Keys (1) on both earphones for 4 seconds to turn them off.

Nate: – To conserve power, if the earphones is not connected to a device for approximately 3 minutes, it will turn off automatically.

BLUETOOTH® PAIRING

Before the first time use, need to pair the earphones with a Bluetooth® device. The pairing is a one-time process and required only for the first connection with the Bluetooth® device.

1. Once turned on, the earphones will automatically enter pairing mode with each other.
   Once paired with each other, the earphones go into pairing mode with the device, recognizable by the flashing red and blue indicator LED;

2. On the external device, turn on the Bluetooth® function and start searching for earphones {refer to its manual for more details);

3. From the list of found devices, select “HMP12E40ENC”;

4. Once paired, the LED indicator will stop blinking.
   Note: – With the paired device, it can happen that the connection is interrupted (e.g. when the connected devices via Bluetooth • stray too far from each other); normally the connection resets automatically, otherwise you must make back the pairing procedure following the instructions above {from point 2 to 4).

   • Whenever you want to pair a new device to the earphones, you must do a further pair repeating pairing procedure following the instructions above {from point 2 to 4).
   • During the pairing, the devices must be at a distance less than one meter in normal use. The maximum distance for correct operation is about 10 metres.
   • If the pairing is not completed within 5 minutes, the earphones will turn off Simply switching on the earphones again and start again with the above procedure from point 1 to 4.

USING FOR MUSIC PLAYBACK

Once music playback starts, you will be able to:

• Pause playback of the song by tapping the Touch multifunction button (1) on the right or left earphone. Press it to resume playback;
• Increase the volume by tapping the right earphone with two quick taps. Decrease it by tapping the left earphone twice;
• Skip to the next song by tapping three quick taps on the right earphone. Skip to the previous song by tapping three quick taps on the left earphone;
• Turn on the phone assistant by pressing and holding on the right or left earphone.

Nate: – These functions are only available an devices that support Bluetooth AVRCP profile.

– Due to the continuous evolution of Buetooth® technology, some devices may nat be compatible or fully compatible with the appliance TREV/ HMP 12E40 ENC.

USING FOR PHONE CALL

When receiving calls on a mobile phone:

Answer a call: tap the Touch multifunction button (1) on the right or left earphone;

End a call: tap the Touch multifunction button (1) on the right or left earbud to end an ongoing conversation;

Reject an incoming call: press and hold the Touch multifunction button (1) on the right or left earbud to reject an incoming call.

TECHNICAL SPECIFICATIONS

Bluetooth® profile: ……………………………….. VS.O
Bluetooth® transmission power: …………….. 2,SmW
Bluetooth® transmission frequency: ……….. 2,4GHz
Battery box: ………………………………………… Rec. inside Li-Poly 300mAh
Earphone Battery: ………………………………… Rec. inside Li-Poly 30mAh
Power supply: ……………………………………… SV ⎓ 1A

WARNING FOR A CORRECT USE OF RECHARGEABLE BATTERY

• Recharge the battery in an ambient temperature between 5°C and 35•c.
• Don’t recharge more than the suitable period to prevent the risk of overheating and burst.
• Recharging the battery over the suitable period or an extended period of inactivity may reduce battery duration.
• Rechargeable battery is liable to wear and tear and its performance will reduce gradually.
• To extend the duration of the battery use it when is completely charged up to the complete discharging, then recharge it fully before use it again. Recharge a battery not completely consumed, will result a reduced duration. In this case, repeat the full charging/discharging cycle many times.

INFORMATION NOTE ON THE REMOVAL AND DISPOSAL OF BATTERIES

Only high-qualified personnel should perform this operation!
Used batteries should not be disposed of with household waste or thrown into fire or water. Used batteries should be recycled or disposed of in separate waste collection center’s.

CUSTOMERS SUPPORT

Strada Consol are Rimini-San Marino, 62
47924 Rimini (RN) Italy
Tel. 0541/756420 – Fax 0541/756430
www.trevi.it – e-mail: info@trevi.it

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>