vikings MCG-S1 Ethernet Media Converter Installation Guide
- June 5, 2024
- vikings
Table of Contents
vikings MCG-S1 Ethernet Media Converter
Overview
This Media Converter is designed to convert 10/100/1000Mbps Ethernet data over inbuilt fiber (MCG-S1) or selectable SFP module (MCG-S2). Fiber port automatically detects 100Mbps and 1000Mbps network speeds.
Package Contents
- MCG-S1 or MCG-S2 Converter x 1
- 5VDC Power Adaptor x 1
- Velcro tape x 1
- This Quick Installation Guide x 1
Installation
- To install Media Converter on a wall or other surface, you can use included Velcro tape. Clean the surfaces before applying the tape.
- Connect your network device to the RJ45 Ethernet port with a network cable.
- For MCG-S2 insert the appropriate and matching SFP module into the SFP port. For MCG-S1 and MCG-S2: connect the fiber cable to fiber port.
- Connect included power adaptor to media converter and plug the power adaptor to your wall-socket outlet (100-240VAC).
- After the device is powered on, the PWR indicator will be on. If the indicator is not on, check the power adaptor and its connection. If all cables are correctly connected, the indicators will lit as per LEDs status.
LEDs status
| LED | Color | Indication |
|---|---|---|
| PWR | Red | Lit when unit is powered |
TX
| ****
Green
| Steady lit when network connection is established on RJ45 port, flashing when transmitting or receiving data
on RJ45 port
FX/ACT
| ****
Yellow
| Steady lit when network connection is established on fiber port, flashing when transmitting or receiving data
on fiber port
Contact information
Vikings Technology Co. LTD. www.vikingstechnology.com support@vikingstechnology.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>