QNAP QHora-301W Wi-Fi 6 and Dual 10GbE SD-WAN Router Installation Guide
- June 5, 2024
- QNAP
Table of Contents
QNAP QHora-301W Wi-Fi 6 and Dual 10GbE SD-WAN Router
What’s In The Box
Front Panel LEDs
LED Behavior
LED | Status | Description |
---|---|---|
Power | Green | The device is ready. |
Status
| Red| A system error occurred while powering on the device.
Flashes green
| · The firmware is updating.
· The device is restarting.
· The device is being initialized.
· The device is locating another device.
Green| The device is ready.
1 Gigabit Ethernet Port| Green| Port link established
Amber| WAN port link established
10 Gigabit Ethernet Port| Green| Port link established
Amber| WAN port link established
Wi-Fi| Green| Wi-Fi link established
Flashes green| Press the WPS button for 3 seconds
Instructions
Audio Alert
Duration | Frequency | Description |
---|
Long and short beeps
|
1 long and 2 short beeps
| The router is resetting configurations and rebooting (reset
button).
2 long beeps and 1 short beep| The router has completed firmware update.
Long beep| 1| The router is starting up.
Short beep
|
10 (every 1 minute)
| The CPU is overheating.
· Verify if the router is adequately ventilated and is
placed in an open space. (Do not stack the router.)
· The alert stops once the temperature is below the threshold limit.
Download Center
www.qnap.com/download
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device maynot cause harmful interference, and (2) This device must accept any interference received, including interference that maycause undesired operation. This equipment has been tested and complies with the Class B digital device limits, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used according to the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference cannot occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by taking one of the following actions:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment. RF
Modules installed in this product must not be co-located or operating in
conjunction with any other antenna or transmitters, except when installed in
accordance with FCC multi-transmitter product guidelines.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for
uncontrolled environments. This equipment must be installed and operated with
a minimum distance of 27cm between the radiator/antennas and the general
public This device complies with CE compliance Class B.
CE Marking
The equipment described in this document faithfully complies with: European
Union Radio Equipment Directive (RED) 2014/53/EU. The Declaration of
Conformity is provided to customers with other technical documents upon
request and is accessible from https://www. qnap.com/en/contact-us/ to
authorized users. Radiation exposure statement This equipment complies with
radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 27 cm between
the radiator and your body. For operation within 5.15 ~ 5.35GHz frequency
range, it is restricted to indoor environment.
Hereby, QNAP Systems, Inc. declares that the radio equipment type QHora-301W
is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the
following internet address: www.qnap.com
Data transmission is handled by software. Via software, it can define the
rule. When the equipment has no data to transmit, only the control frame will
be sent (like 802.11 management frame, such as beacon and probe Response).
When failing to operate, it will stop the service automatically
ISED Compliance Statement
Innovation,Science and Economic Development Canada (ISED) Statement:
This Class B digital apparatus complies with Canadian ICES-003.
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
Radiation Exposure Statement
This product comply with IC radiation exposure limits set forth for an
uncontrolled environment. To comply with RSS 102 RF exposure compliance
requirements, a separation distance of at least 27 cm must be maintained
between the antenna of this device and all persons.
The device for the band 5150-5350 MHz is only for indoor usage to reduce
potential for harmful interference to co-channel mobile satellite systems.
According to the requirement of the WEEE legislation the following user
information is provided to customers for all branded QNAP Electronics products
subject to the WEEE directive.
This symbol on the product or on its packaging indicates that this product must not be disposed of with your other household waste. Instead, it is your responsibility to dispose of your waste equipment by handing it over to a designated collection point for the recycling of waste electrical and electronic equipment. The separate collection and recycling of your waste equipment at the time of disposal will help to conserve natural resources and ensure that it is recycled in a manner that protects human health and the environment. For more information about where you can drop off your waste equipment for recycling, please contact your local city office, your household waste disposal service or the shop where you purchased the product.
RED 2014/53/EU Article 10 Compliance
RED 2014/53/EU requires that for products which could potentially have an
issue with a non-harmonized frequency in a specific EU country, the product
documentation must list the restrictions, and the packaging must carry a label
reflecting that country’s code.
EU RoHS statement
This equipment complies with the European Union RoHS Directive 2011/65/EU on
the restriction of the use of certain hazardous substances in electrical and
electronic equipment. The directive applies to the use of lead, mercury,
cadmium, hexavalent chromium, polybrominated biphenyls (PBB), and
polybrominated diphenyl ethers (PBDE) in electrical and electronic equipment.
www.qnap.com
helpdesk.qnap.com
docs.qnap.com
References
- docs.qnap.com
- Customer Service - QNAP
- Contact Us | QNAP
- QNAP (US) | Experts in NAS, Networking, and Smart Surveillance
- Download Center | QNAP (US)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>