AUKEY PM-YY Dashboard Camera Hardwire Kit User Manual
- June 5, 2024
- Aukey
Table of Contents
AUKEY PM-YY Dashboard Camera Hardwire Kit
Specifications
| Model | PM-YY |
|---|---|
| OBD-II DLC Port Input | 8V – 36V (8V – 12V is standard in cars) |
| Mini-B Output | 5V 2A |
| Motion Sensor Range | 2 – 3m / 6.56 – 9.84ft |
| Cable Length | 3.2m / 10.5ft |
| Weight | 80g / 2.82oz |
Product Diagram
Installation
The diagram below shows the recommended cable routing and the placement of the
motion detection sensor in your car. 
- Connect the mini-B connector of this hardwire kit to your AUKEY or another dash camera, and connect the “Battery +”(red wire) to positive pole of fuse box, “GND”(black wire) to the negative pole of the fuse box, “ACC” to the AC port of fuse box (see notes below)
- Use the 3M adhesive pad to stick the motion detection sensor to the windshield in a position similar to that shown in the above diagram
- Arrange the cable conveniently and safely so it won’t distract you or dangle in the way of the car foot pedals or door. Careful placement of the cable and use of existing trim to conceal it will give a tidier finish
Notes
It is advisable to connect and test the hardwire kit to ensure it operates
correctly and supplies power to your dash camera before fixing the motion
sensor and tidying up the cable
Parking Mode
All AUKEY dash cameras and many other dash cameras feature a motion detection recording mode (parking mode). With this mode switched on and the hardwire kit successfully installed, your dash camera will start recording when motion is detected within 2 – 3m / 6.56 – 9.84ft. The hardwire kit motion detection sensor provides 360° detection for improved coverage compared to dash camera visual detection. The camera will operate even when the car ignition is turned off.
Notes
- Motion detection mode is power efficient because the camera only operates when triggered and for short periods at a time
- The hardwire kit automatically cuts off power if battery voltage drops to 11.6V, to protect the car battery and avoid excessive discharge. However, it is advisable to disconnect the power by unplugging the mini-B connector of this hardwire kit to your AUKEY or another dash camera when the car is parked or stored for longer periods
Product Use & Care
- Refer to your car owner’s manual (or similar information online) for the location of the fuse box if they’re difficult to locate by visual inspection
- When connecting the fuse box, be careful not to touch or accidentally loosen fuse box wires. Loose wiring may cause operational and safety issues Position the parts of the kit and its cable safely so it won’t obscure your view or get in the way of your feet and the foot pedals
- Compatible with all dash cameras with mini-B power input, including AUKEY DR01, DR02, DRA1, DRA5, DRS2, DRS1, and DR02 D
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>