Aukey PB-MS02 MagLink 38.5wh 10000mah Magnetic Wireless Charging Power Bank User Manual
- June 1, 2024
- Aukey
Table of Contents
USER MANUAL
MagLink 10K
PB-MS02 MagLink 38.5wh 10000mah Magnetic Wireless Charging Power Bank
Charging Your Phone or Tablet Using Charging Cables
Charging Your Phone Wirelessly
Ready to wireless charge Charging Foreign object detected
Charging Your Smart Watch or Bluetooth Earphones
- Enter low-current charging mode: Press and hold the power button for 3 seconds, and three white LED lights turn on and off alternatively every 6 seconds.
- Charge your smart watch, Bluetooth earphones, or other low-power accessories.
- Exit low current charging mode: Press and hold the power button for 3 seconds.
Charging Devices Wirelessly and Using Cables Simultaneously Recharging
Your MagLink 10K
Notes
- The USB-C port supports USB Power Delivery fast charging for iPhone 8 and later when used with a certified Apple USB-C to Lightning cable.
- This product can provide perfect magnetic alignment for iPhone 12 / 13 / 14 / 15. Dieses Produkt bietet eine perfekte magnetische Ausrichtung für das iPhone 12 / 13 / 14 / 15.
Product care and precautions
-
Do not impact or drop the product.
-
Keep away from liquids and extreme heat.
-
Recharge the power bank at least once every 3 months.
-
Do not leave the product in the car for a long time.
-
Do not leave the product in the car for a long time.
-
Do not disassemble or modify.
-
Please stop using the product immediately and contact the support center in the following cases.
– The product emits smoke
– The product leaks liquid
– The product has an abnormal smell such as burnt smell -
Batteries should be disposed of according to local environmental law.
** This product complies with the radio interference requirements of the
European Community.
Declaration of Conformity
This product is intended for use within Europe. This equipment compiles with
the essential requirements for the Radio Equipment Directive 2014/53/EU. AUKEY
Technology Co., Ltd. hereby declares that this product PB-MS02 is in
compliance with the essential requirements and other relevant provisions of
Directive 2014/53/EU, 2014/35/EU, 2014/30/EU. The Declaration of Conformity
for the PB-MS02 is available from www.aukey.com
** This symbol indicates that this product shall not be treated as
household waste. Instead it shall be handed over to the applicable collection
point for the recycling of electrical and electronic equipment.
Warranty & Customer Support
For questions, support or warranty claims, please contact your seller
directly.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure statement.
The device can be used in portable exposure condition without restriction.
Specifications
| Model | PB-MS02 |
|---|---|
| Battery capacity | 10000mAh / 38.5Wh |
| Rated capacity | 6400mAh |
| Battery type | Lithium polymer |
| Input | USB-C: 5V 3A / 9V 2A / 12V 1.5A (18W Max) |
| Output | USB-C: 5V 3A / 9V 3A / 12V 2.5A 15V 2A (30W Max) |
Wireless: 15W (Max) / 10W / 7.5W / 5W
Total output| 30W
---|---
Operating temperature| 0-40C
Storage temperature| -10-45 C
Dimensions I Mane I Dimensions| 109 x 68 x 19.2mm / 4.29″ x 2.68″ x 0.75″
Weight| 210g / 7.41oz
Follow Us to Unlock More about AUKEY:
@AUKEYofficial
@aukeyofficial
@AUKEYofficial
AUKEYofficial
Model: PB-MS02
Aukey Technology Co., Ltd.
www.aukey.com |
support@aukey.com
Room 116, Kangli Information Valley Building, Shanglilang Community,
Longgang District, Shenzhen, Guangdong, 518111, China
FCC ID：2ATIH-PB-MS02
Made in china
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>