AUKEY T28 Magnetic Charging Case User Manual
- June 3, 2024
- Aukey
Table of Contents
AUKEY T28 Magnetic Charging Case
Safety warning
- Do not put this product into fire or water to avoid short circuit leakage or damage to the product.
- Please check the product, data cable and other accessories before use. Immediately stop using the product if you notice any damage.
- Do not use this product in a high temperature, humid or corrosive environment, so as not to damage the circuit and prevent charging or other
- Do not contact the product with corrosive liquids, otherwise it will cause serious damage and the product will not be guaranteed.
- Do not disassemble or modify this product for any reason, so as to avoid secondary failure and burning, which is not covered by the warranty.
Made for iWatch
- iWatch 2
- iWatch 3
- iWatch 4
- iWatch 5
- iWatch 6
- iWatch 7
- iWatch 8
- iWatch SE
Specifications
- Model: T28
- Input: 5V 1A
- Output: 3W MAX
- Input interface: Type-C
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to
operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF exposure statement:
The equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance between 20cm the radiator your body.
Made in China
Shenzhen Yifeng Intelligent Technology Co., Ltd.
S/N:2AXY5-T28
FCC ID:2AXY5-T28