AUKEY HD-C60 Wireless Charging Phone Mount User Manual
- June 4, 2024
- Aukey
Table of Contents
AUKEY HD-C60 Wireless Charging Phone Mount
Thank you for purchasing the Goto9i HD-C60 Wireless Charging Phone Mount. Please read this user manual carefuly and keep it for fufure reference. If you need any assistance, please contact our support team with your product model number and Amazon order number
Package Contents
- Wireless Charging Phone Mount
- USB-A to C Cable
- User Mainual
- Quick Start Guide
- Waranty Card
Product Diagram
Specifications
Getting Started
- Unscrew the pivot locking nut until you can push the ball joint into the back of the mount; then tighten the nut (not too tight, so it will be easier to adjust the angle of the mount later)
- Unscrew the nut to the left and adjust the length of the hook
- Push the hook into the air vent grille to catch a blade, then tighten the screw nut until the hook securely locks onto your air vent
- Use the provided USB-A to C cable to connect the phone mount to a USB charging port in your car. Connect to a Quick Charge 2.0/3.0 USB car charger for wireless fast charging
- Pivot the mount so it faces you directly when seated in the car. Fully tighten the pivot locking nut while holding the mount
- Press the phone cradle release button
- Place your phone on the phone rest. Extend the phone rest to fit your device. For wireless charging make sure the center of your device is aligned with the wireless charging area
- Push the phone cradle arms back in, pressing the back edge of the cradle arms is so They grip yoUr phone secure
Product Care & Use
Keep away from children. The small parts pose a choking hazard if swallowed
Warranty & Customer Support
For questions, support, or warranty claims, contact us at the address below that corresponds with your region. Please include your Amazon order number and product model number.
Caution: Any changes or modifications to this device not explicitly
approved by the manufacturer
could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation
The device has been evaluated to meet general RF exposure requirements.
The distance between user and products should be no less than 20cm.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>