BaByliss AS136E Air Style Heated Hair Brush User Guide
- October 26, 2023
- BaByliss
Table of Contents
Frigidaire Gallery Refrigerator Rev...
Frigidaire Gallery Refrigerator Review
BaByliss AS136E Air Style Heated Hair Brush
Read the safety instructions first.
HOW TO USE
- Ensure the hair is 80% dry and combed through to emove any tangles.
- Create your parting and divide the hair into sections ready for styling.
- Secure the selected attachment onto the handle. To interchange between the attachments, refer to the ‘Changing the Attachments’ section.
- Slide the switch to the setting suitable for your hair type to turn the appliance on.
- After use, slide the switch to the ‘0’ position to switch off and unplug the appliance.
- Allow the appliance to cool before storing away.
Changing the Attachments
- Place the attachment onto the handle and line up the two indents with the buttons on the handle.
- Push the attachment onto the handle until it clicks into place.
- To remove an attachment, press and hold the two buttons and pull the attachment away from the handle.
Drying Nozzle Attachment
- Direct the airflow onto the hair and move the airstyler around the head to remove excess moisture pre-styling.
Smooth Blow-dry Brush Attachment
- Place the brush head under a section of hair, close to the roots with the bristles pointing upwards.
- Use your other hand to pull the hair section taut against the brush head.
- Gently glide the brush head through the section of hair, until you reach the ends.
- Repeat for each hair section.
50mm Volumising Brush Attachment
- Place the brush head under a section of hair, close to the roots.
- Use the brush to lift the hair at the roots to create volume.
- Slowly move the brush down along the section, towards the ends of the hair.
- Repeat for each section of hair.
Conical Attachment
- Take a section of hair and place the barrel next to the hair section, ensuring the end of the appliance is pointing down towards the shoulder.
- Start by winding the hair around the widest part of the barrel.
- Keep winding the hair down the length of the barrel.
- Hold in the hair for 5-8 seconds, depending on hair type. Then unwind or release the section of hair and pull the appliance away.
Heat Settings
There are 2 heat settings plus a cool setting. Slide the switch to the first
position to select the cool setting ‘*’, the second position for the low heat
‘I’, and the third position for the high heat ‘II’.
Please note: If you have delicate, fine, bleached or coloured hair, use the
low heat setting. For thicker hair, use the high heat setting.
Heat Protective Glove
IMPORTANT: A universal heat protective glove has been supplied to help protect the hand from temporary contact with the barrel when wrapping the hair around the appliance. Please note the heat protective glove is only designed to give initial contact protection. Discomfort will be caused with prolonged contact with the hot surface.
CLEANING & MAINTENANCE
- To help keep your appliance in the best possible condition, please follow the steps below:
General
- Ensure the appliance is switched off, unplugged and cool. To clean the outside of the appliance, wipe with a damp cloth. Make sure that no water enters the appliance and it is completely dry before use.
- Do not wrap the lead around the appliance, instead coil the lead loosely by the side of the appliance.
- Do not use the appliance at a stretch from the power point.
- Always unplug after use.
Cleaning the Filter
- Ensure the appliance is switched off, unplugged and cool.
- Using a soft brush, clean any hair and other debris from the filter.