LOGIC B8K Big Button Social Phone User Guide
- June 5, 2024
- Logic
Table of Contents
B8K
Big Button Social Phone
User Guide
Thank you for purchasing this innovative LOGIC device. The specifications in
this document are subject to change without prior notice.
LOGIC and the LOGIC logo are registered trademarks of Swagtek, Inc. Other
trademarks are the property of their respective owners.
Charge for 24 hours before using.
Install SIM card/memory card.
Get to know your Logic phone
Connect your Logic phone to the computer using a USB cable (not included).
Copy music files from your computer to your Logic phone.
FCC Statement
-
This device complies with Part IS of the FCC Rules. Operation ks subject to the following two conditions,
(1) Tit device may rot and cause harmful interference.
(2) This device must accept any Interference received inducing interference trot may cause undesired operation. -
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
NOTE
This equipment has been tested and found to comply with the Winks for a Class
B digital device. pursuant to Port 15 of the FCC Rules. These Imes are
designed to provide reasonable protection Ernst harmful interference in a
residential institution.
This equipment generates uses and can radiate redo frequency energy and. If
not installed and used in accordance with the instructions may cause harmful
interference to radio communications. However. there is no guarantee that
interference will not occur in a particular installation If this equipment
does case harmful interference to radio or television reception which can be
determined by turning the equipment off and all the user Is encouraged to try
to correct the interference by one or more Of the following measliest Reorient
a reboot° the receiving antenna. Increase the separation between the equipment
ad receiver.
Connect the equipment Into on cutlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced redid/TV technician for help.
SAR Information Statement
Your wireless phone is in a ratio between transmitter and receiver. It is
designed and manufactured not to exceed the emission units fa exposure to
radiofrequency (FE) energy set by the Federal Canmuncotans Commission of the
US Government. These Imes are part of comprehensive guidelines and eStebnh
permitted levels Of RF energy for the general population The guidelines are
based on store: lords that were developed by independent scientific
organizations through periodic and thorough evaluation of scientific studies.
The standards Include a subsumed safety margin designed to assure the safety
of all persons. rogation of age aril health The exposure standard for wireless
noble phones employs o unit of measurement brown as the Specific Absorption
Rate. or SAR The SAR knit set by the FCC is 16 W/kg ‘ Tests for SAR are
conducted with the phone transmitting at its highest certified power level in
dl tested frequency bonds Although the SAR is determined at the highest
certified power level the actual SAR level of the phone stole operating con be
well below the maximum vols. This is because the phone is desired to operate
at multiple power levels so as to use only the power required to reach the
network. In general, the closer you are to o wireless hose station antenna
does loner the power output. Bette a phone model is mailable for sole to the
public. it mint be tested and certified by the FCC that it does not exceed the
knit established by the government adopted requirement for safe exposure. The
tests are performed in wallas and locations (e.g, at the ea and wan and the
body) as required by the FCC for each model. The highest SAR value for this
medal phone when tested for use at the ear is 0336W/Kg and when worn on the
body. as described in the iris user guide. G 0.472W/Kg(Body-worn measure tents
‘after among phone models depending upon available accessories and FCC
requirements). The madman scaled SAP h hotspot mode Is 0.498W/Kg. While there
may be differences between the SAP levels of various phones and at various
positions. they all meet the government requirement for safe exposure. The FCC
has granted an Equipment Authorization for (Ns model phone with all reported
SAR levels evaluated as in compliance with the FCC PFeemsu-e guidelines. SAP
information on this model phone Is on file with the FCC and can be found under
the Display Grant section of http://www.fcc.gov/oet/fccid after searching on
FCC ID: 055243221 Additional information on Specific Absorption Rotes
(SAR) can be fond on the Cellular Telecommunications Industry Asso-lotion
(CTIA)
website at http://www.wow-com.com. In the United States and Canada the SAP
limit for mobile PhOnOS used by the public is 1$ watts/kg (W/IS) demerged over
One Tan Of ti sue The standard incorporates a substantial marsh of safety to
lye additional protection for the public and to account for variations in
measurements.
Body-worn Operation
This device was tested for typical body-worn operations. To comply with RF
exposure requirements. a mina sin seperation distance of 10mrn must be
mortared between the user’s body and the handset. including the antenna.
Third-poly belt-dips, holsters. and similar accessories used by this device
should not canton any metallic components.
Body-worn accessories that do not meet these requirements may not comply with
PF exposure requirements and should be avoided. Use only the supplied or an
approved antenna.
Note: As all other dances. sore leaves described in this quick guide may
be available depending on network capabilities or rodio interference. Some
networks don’t support Emergency calls, Therefore. do not rely only on the
device for important communication. as Frist Aide. Please check with your
Service provider.
Note: If you have an easy phone lock (keypad lock) enabled the prone can
still make emergency calls. just press and hold the Key to unlock the phone,
dial 911, and press the Call Dial key.
Warranty Certificate Terms and Conditions
LOGIC warrants that its products will be free from defects in material and
workmanship.
The warranty period is one (1) year for the products and three (3) months for
the accessories which are part of the original package including the battery.
The warranty period begins on the date of purchase by the End-User who shall
present an invoice or a purchase receipt when requiring warranty service
otherwise the warranty period will begin from the date of manufacture of the
product. LOGIC will repair a product without cost to the customer if it
presents a manufacturing defect or defect in workmanship during the warranty
period and if the defect occurred under normal conditions of use in accordance
with the instructions and specifications stated in the user’s manual.
For additional information about the terms and conditions of LOGIC’s Limited
Warranty or to obtain warranty service information,
please visit the support section at:
logicmobility.com
makes sense
logicmobility.com
Made in China Copyright Swa9tek, Inc. 2021
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>