Roco 70760 Diesel Locomotive Class 215 User Manual
- June 5, 2024
- Roco
Table of Contents
Roco 70760 Diesel Locomotive Class 215
Starting locomotive operation
Unwrap model:
Take out the model cautiously with foil (fig. 1).
Operating instructions:
Before use is advisable to let the loco go around about 30 minutes forwards and 30 minutes backwards without load, to obtain an optimal circuit and best tractive power. The smallest radius this model should run is the R2 of the ROCO track system (R2 = 358 mm). Your locomotive will run smoothly on clean tracks only. For this purpose, we recommend using item no. 46400, Roco track cleaning van, or item no. 10002, Roco track cleaning rubber, for removing heavy dirt.
Fittings:
Operation is possible with different couplings (fig. 2). We recommend using
the Roco close coupling. In the enclosed accessory bag you will find small
kits to be fitted on your locomotive. Please mount them cautiously. Attention!
Use glue only if indicated (fig. 2).
Running in digital mode:
Remove the jumper from the interface. Finally, put the plug of the chip into the interface as shown in fig. 6.
Maintenance of the model
To enjoy your model for a long time, it is necessary to service it regularly (i.e. after it has been in operation for approximately 30 hours).
- Cleaning of wheel contacts: Wheel contacts easily get dirty on tracks which are not entirely clear. Use a small brush to remove dirt from spots marked in fig. 4.
- Lubrication: Apply tiny oil drops to spots marked in fig. 7. Prior to lubrication dismantle the locomotive (fig. 3). We recommend using item no. 10906, Roco oiler. For lubrication the gear parts (e.g. cogwheels, worm) we would recommend our Roco special grease (item no. 10905). Attention: Please do not oil these parts when using our grease.
- Change of traction tyre : Remove the gear cover (fig. 8). Take out the wheelset and remove the traction tyre using a pin or a fine screwdriver (fig. 8). When pressing on the new traction tyre please avoid twisting it.
- Motor Changing : First, remove the loco body (fig. 3), and then the motor (fig. 9).
- Assembly : During assembly please take care of the correct position of contacts.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>