Roco H0 Steamlocomotive Class Oi2-10 PKP User Guide
- June 4, 2024
- Roco
Table of Contents
Roco H0 Steamlocomotive Class Oi2-10 PKP
Unwrap model
Take the loco carefully out of the packing with the help of the foil (fig. 1).
Very important!
Before taking into service your model these bearings of the coupling rods must
be oiled as otherwise there would be the risk of bad running qualities of
damage to the locomotive (see fig. 8).
Operating instructions
Before use is advisable to let the loco go around about 30 minutes for-wards
30 minutes backward without load, to obtain an optimal circuit and best
tractive power. The smallest radius this model should run is R3 (419,6 mm) or
rather R2 (358 mm) of the ROCO track system (model without tubes protection
pis-tons would run only if driven very carefully on R2) (fig. 2). 
Your locomotive will run smoothly on clean tracks only. For this purpose, we recommend using item no. 46400, ROCO track cleaning van, or item no. 10002, ROCO track cleaning rubber, for removing heavy dirt.
Fittings:
Operation is possible with different couplings (fig. 3). We recommend using
the ROCO close coupling.
In the enclosed accessory bag you will find small kits to be fitted on your
locomotive. Please mount them cautiously. Attention! Use glue only if
indicated (fig. 3).
Running in digital mode
First, remove the Tender body (fig. 7). Then remove the jumper from the
interface. Finally, put the plug of the chip into the interface as shown in
fig. 5.
Maintenance of the model
To enjoy your model for a long time, it is necessary to service it regularly
(i.e. after it has been in operation for approximately 30 hours). Uncouple
locomotive and tender first (fig. 4).
Cleaning of wheel contacts:
Wheel contacts easily get dirty on tracks that are not entirely clean. Use a
small brush to remove dirt from spots marked in fig. 9.
Lubrication:
Apply tiny oil drops to spots marked in fig. 8. Prior to lubrication dismantle
the loco body or the tender body (fig. 7). We recommend using item no. 10906,
Roco oiler. For lubrication of the gear parts (e.g. cogwheels, worm) we would
recommend our Roco special grease (item no. 10905).
Attention:
Please do not oil these parts when using our grease.
Steam generator application (fig. 6):
First, remove the smokestack and then push in the Seuthe steam generator
no. 10 (running in digital mode: use no.11).
Change of traction tyre:
Remove the tender gear cover. Take out the wheelset and remove the traction
tire using a pin or a fine screwdriver (fig. 11). When pressing on the new
traction tire please avoid twisting it.
Carbon Brush Changing:
First, remove the tender body (fig. 7), and then the motor (fig. 10).
Assembly
During assembly please take care of the correct position of contacts.
More information about the sound decoder can be found here.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>