Wyze WDBC1 Wired smart door bell camera security User Manual
- June 5, 2024
- Wyze
Table of Contents
Wyze WDBC1 Wired smart door bell camera security
IN THE BOX
-
Wyze Chime
x 1 -
Quick Start Guide
x 1
SETUP
Insert Wyze Sensor Bridge into the USB port of a Wyze Cam or Wyze Cam Pan and wait for the Status Light to turn solid blue.
- Notice: 1. Wyze Chime can only connect to Wyze Sensor Bridge (included in Wyze Sense Starter Kit) which is connected to Wyze Cam or Wyze Cam Pan.
- Wyze Chime can also connect to Wyze Video Doorbell. Please refer to the Wyze Video Doorbell manual for details.
Notice :Wyze Sensor Bridge is not included.
- Insert Wyze Chime into an outlet.
- Open the Wyze app and tap the 3 dots on the top right corner of the Home Page. Select “Add a Product” and then select Wyze Chime. Follow the instructions in the Wyze app to finish setup.
- Connect multiple Wyze Chime devices, please repeat the steps
LIGHT INDICATIONS
- Solid yellow light Unconnected
- Flashing blue light On connection
- Solid blue light Successful connection
FCC Statement
Changes or modifications not expressly
approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
ISEDC RSS Warning
This device complies with ISEDC licence-exempt RSS standard (s). Operation is
subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference,including
interference that may cause undesired operation of the device.
ISEDC Radiation Exposure Statement:
This equipment complies with ISEDC RF radiation exposure limits set forth for
an uncontrolled environment. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.