VicTsing PC299A Wireless Mouse User Manual
- June 5, 2024
- VicTsing
Table of Contents
VicTsing PC299A Wireless Mouse
Packing List
Mouse x 1 USB Receiver x 1
User Manual x 1
VIP Card x 1
Diagram
- Left Button
- Right Button
- Scroll Wheel
- Switch
- USB Receiver Stored in battery compartment
Featurees
Stable Wireless Connection
With 2.4CHz wireless technology. this mouse can be stably connected to use within 10m.
More Power saving
Equipped with the first-rate chip. the mouse is 5 times power-saving than normal mouse. The standby time can reach up to 24 months.
Mute Button Design
Adopted independent micro mute switch, this mouse can reduce noise by 90% above. You don’t need to worry about disturbing about others.
Instructions
- Take a AA dry battery into mouse with correct polarity direction, and turn on its bottom switch.
- Take out USB receiver and plug it into computer.
- It’s workable after its driver is installed on computer automatically.
Warning
Changes or modifications to thIS unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE
This device complies of the FCC Rules. Operation is subject to the following
two conditions. This device may not cause hamful interference, and this
device must accept any interference received, including interference that may
cause undesired operation.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant of the FCC Rules. These limits are designed to provide reas onable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause hamful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consut the dealer or an experienced radio/TV technician for help.
RF exposure compliance statement
This device has been evaluated to meet the general RF exposure requirement