katranji DSO150 DIY Oscilloscope Kit User Manual
- October 27, 2023
- katranji
Table of Contents
katranji DSO150 DIY Oscilloscope Kit
Requirements
- USB Power Supply cable or Lithium Battery 3.7V (optional)
- AC or DC Voltage 0 – 5V MAX or optional Signal Generator
- Testing Probes
Instructions
-
Connect the probes cable in one of the following Channels (CH1 – CH2)
-
Connect the USB Power cable or use the Battery Switch to turn on the Oscilloscope
-
Once the power is connected; LCD will turn on. Adjust the trimmer for LCD contrast at the rear side by an isolated screwdriver
-
Choose the Number of testing Channels CH1 – CH2 testing by turning Slide Switch (SW1) to left ←
-
The tested signal can be paused by turning Slide Switch (SW1) to Right → , the screen will show the Single function in the right bottom corner and will pause the shown tested signal with READY message, push (SW1) to show the next cycles of the signal, to get back to instant testing signal turn the Slide Switch (SW1) Right →, the screen will show the AUTO function and review instant signal testing.
-
The signal cycle can be determined in Micro & Milli seconds by turning the Slide Switch SW2 right→ and Left ←
Starting the following:
100 – 200 – 500 uS Microseconds
1 – 2 – 5 – 10 – 20 – 50 – 100 – 200 – 500 – 1000 mS milliseconds
-
Scroll Offset to adjust the signal X-Axis Offset
-
Use the Level to adjust the signal input voltage between 0v to 5.1V
-
Push the slide Switch SW2 to turn the testing signal between – and +
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>