Lorex AK41TK on window Door sensor User Manual

Lorex AK41TK on window Door sensor

Package Contents 

Overview

Specifications

• Environment: Indoor
• Max detection distance: Less than 3/4″
• Operating temperature: 14°F~113°F
• Operating humidity: 0-95%RH
• Battery: CR1632
• Protocol: Bluetooth 5.0

LED Behavior

See the table below for definitions of the sensor’s LED behaviors:

WARNING:
CHOKING HAZARD
KEEP OUT OF REACH OF CHILDREN
Lorex products come with a standard 1-year  warranty. For more information about Lorex’s warranty policy, visit lorex.com/warranty

STEP 1: Pairing to Your Device To connect the sensor to your device

1. Tap the Lorex Home icon to launch the app.
2. In the Devices tab, press +Add sensor to set up the sensor Tap the+ icon on the top right of the screen to add more sensors. NOTE: the screen to the left is taken from the Sensor Hub.
3. Follow the on-screen prompts to complete the rest of the setup. The Lorex Home app will walk you through the process, step by step.

STEP 2: Installing the Sensor

Location tips:

• The sensor can be installed indoors, on any door or window.

• If you’re using a door, place the sensor at the top of your door to keep safe from being bumped and Out of reach from children and pets.

• The sensor and magnet line up together and must be installed that way.

• The sensor and magnet can be no more than 3/4″ apart to send a signal to the hub.

  1. Pick an area for the sensor to be placed.

  2. Ensure that the bluetooth connection is steady to the hub before mounting.
     TIP: test by setting the different modes for the sensors in the app.

  3. IMPORTANT: Install the magnet to the right of the sensor.
     Peel the mounting adhesive and stick it to the frame.
     Attach the sensor. Repeat this step for the magnet and attach it to the door/window.

  4. Open and close your door/window, the sensor should stay in place.

Changing the Battery

1. To change the sensor’s battery: Make sure your system is disarmed.

2. Use the wide part of the pin to open the sensor from the battery slot.

3. Slide the old battery out and replace it with the new one.
   NOTE: This sensor uses a CR1632 battery. Snap the sensor closed with the battery

4. slot meeting the Lorex logo at the top.

References

• Security Cameras - Home Security Camera Systems | Lorex

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>