JETSON JFORCE-BLK Force Light-Up Extreme Terrain Combo User Guide

JETSON JFORCE-BLK Force Light-Up Extreme Terrain Combo

What’s in the Box

1. Vega Hoverboard
2. Foot Rest
3. Front Wheel
4. Frame Tube 

Tools needed but not included: Allen Key & Spanner
CAUTION: Before operating the Force Combo please tighten all nuts and bolts.

Specs & Features

Vega

• Max Speed: Up To 9 mph
• Max Range: Up To 12 miles
• Battery: 25.2V, 4.0Ah Lithium-Ion
• Motor: 500W Dual Hub Motor, (250w x 2)
• Product Weight: 17 lb
• Product Dimensions: 24.5″ x 8″ x 7.5″
• Tire Size: 6.5″
• Charger: UL Listed, 100-130V
• Charge Time: Up To 3 Hours
• Climbing Angle: Up To 15°
• Weight Limit: 220 lb
• Recommended Age: 12+

Force

• Weight Limit: 220 lb
• Recommended Age: 12+
• Product Weight: 17 lb
• Product Dimensions: 39″ x 22.5″ x 12″

*Adults must assist children in the initial assembly and adjustment procedures to fold/unfold product and adjust handlebars.

Get Started

Charging the Battery

• Only use the included charger
• Plug the charger into the wall before the Charging Port
• Don’t turn on the Vega while it’s charging
• Charge the battery until it is fully charged – up to 3 hours

CHARGING INDICATOR ON THE CHARGER Indicator Lights

Warning: The Vega will automatically slow down and lean up once the battery power goes below 10% as a safety precaution.
Status Indicator Light – Lights up blue when you step onto the Vega. If the Status Indicator Light turns red or if you are having issues with the Vega, you may need to recalibrate it.

How to Recalibrate 

Follow these 3 simple steps …

1. Place the Vega on a flat, level surface and hold still.
2. Hold the Power Button (for about 5 seconds) until you are notified of a successful recalibration.
3. Restart the Vega by turning it off and then on.

Connecting to Bluetooth®

The Vega comes equipped with Bluetooth® speaker.

To connect to your Bluetooth® speaker:

• Turn on the Vega, and it will become discoverable to your handheld device.
• Activate your Bluetooth® in your handheld device’s settings.
• Find the Vega in your handheld device’s list and select it.
• Now you can play your music.

Assembly

Assembling the Handles

Adiusting the Foot Rest

Attaching the Force

Please Note: Images may not reflect exact appearance of actual product.

Make Moves

Riding the Vega

Turning the Lights On

Follow these 3 simple steps …

1. Connect the wire at the back of the Seat into the Charging Port.
2. Make sure the Connector is secure.
3. Power the Vega on and the Seat Light will turn on.

Please Note: The Connector should always be connected while riding.

• The default lighting mode will display when the Force and Vega are both connected and powered on.
• Short press the power button to switch between 4 lighting effects.

Lighting effect modes:

1. Inward Lighting Effect
2. Outward Lighting Effect
3. Flashing Lighting Effect
4. Cool Blue Lighting Effect

Riding the Force

1. Place the Force on a flat surface with the Vega turned off.
2. Carefully take a seat and place your feet on the Foot Rest.
3. Make sure the Vega is leveled.
4. Now it’s time to turn on your Vega.

Note: If the Vega is not leveled when you turn it on, the Force will go forward or backward immediately. Tighten all screws and locking nuts before each ride to ensure they are tight.

Care& Maintenance

CLEANING THE Force
To clean the Force, carefully wipe with a damp cloth, then dry with a dry cloth. Do not use water to clean the Force, this may damage the frame or seat.

THE Vega
To clean the Vega, carefully wipe with a damp cloth, then dry with a dry cloth. Do not use water to clean the Vega, as the electrical and electronic systems may get wet, resulting in personal injuryY or malfunction of the Vega. If the electric parts or battery get wet, do not power on the Vega. Please contact Jetson Customer
Support for assistance.

FEW MUST-DO’S
Keep away from fire and excessive heat. Avoid intense physical shock, severe vibration, or impact. Please ride the Force on a smooth, flat surface.
Protect from water or moisture. Contact Jetson Customer Support if there are any issues with the Force.

RIDING RANGE

The maximum range is 12 miles. However, many factors will affect how far you can go per charge:
Driving Surface: A smooth, flat surface will increase driving distance.
Weight: More weight means less distance
Temperature: Ride, store, and charge the Vega above 5o°F
Maintenance: Timely battery charging will increase driving distance.
Riding Style: Frequent starting and stopping will reduce driving distance.

BATTERY

Keep away from fire and excessive heat.
Avoid intense physical shock, severe vibration, or impact.
Protect from water or moisture.
Do not disassemble the Vega or its battery.
Contact Jetson Customer Support if there are any issues with the battery.

STORAGE

Fully charge the battery before storing. The battery should be fully charged once a month after this.
Cover to protet against dust.
Store indoors, ina dry place.

MODIFICATIONS
Do not attempt to disassemble, modify, repair, or replace the product or any components of the unit without instruction from Jetson Customer Support. This will void any warranty, and can lead to malfunctions which may cause injury.

ADDITIONAL OPERATION CAUTIONS
Do not lift the product off the ground while it is on and the wheels are in motion. This can result in freely spinning wheels, which may cause injury to yourself or others nearby. Do not jump on or off the product, and do not jumpP while using it. Always keep your feet firmly planted on the mat sensors while in operation. Always check the battery charge before using.

Safety Warnings

• Before use, please read the user manual and safety warnings carefully, and make sure you understand and accept all the safety instructions. The user will be responsible for
  any loss or damage caused by improper use.

• Before edch cycle of operation, the operator shall perform the preoperation checks specified by the manufacturer: That all guards and pads originally supplied by the manufacturer are in proper place and in servicedble condition; That the braking system is functioning properly; That ny and all axle guards, chain guards, or other covers or guards supplied by the manufacturer are in place and in serviceable condition; That tires are in good condition, inflated properly, and have sufficient tread remaining; The area that the product is to be operated should be safe and suitable for safe operation.

• Components shall be maintained and repaired in accordance with the manufacturer’s specifications and using only the manufacturer’s authorized replacement parts with installation performed by dedlers or other sKiled persons.

• Warning against recharging non-rechargeable batteries.

• Don’t allow hands, feet, hair, body parts, clothing, or similar articles to come in contact

• With moving parts, wheels, or drive train, while the motor is running.

• This product should not be used by children or persons with reduced physical, sensor yor mental capabilities, or lack of experience and knowledge, unless they have been  given supervision or instruction (IEC 60335-1/A2:2006).

• Unsupervised children should not play with the product (1EC 60336-1/A2:2006).

• Adult supervision is required.

• The rider should not exceed 220 lb.

• Units shall not be operated to perform racing, stunt riding, or other maneuvers, which may cause loss of control, or mayY cause uncontrolled operator/passenger actions or redctIons.

• Never use near motor vehicles.

• Avoid sharp bumps, drainage grates, and sudden surface changes. Scooter may Suddenly step.

• Avoid streets and surfaces with water, sand, gravel, dirt, leaves, and other debris. wet weather impairs traction, braking, and visibility.

• Avoid riding around flammable gas, steam, liquid, or dust that could cause fire.

• Operators shall adhere to all of the manufacturer’s recommendations and instructions, as well as comply with all laws and ordinances: Units without headlights shall be operated only with adequate daylight conditions of visibility, and; Owners shall be encouraged to highlight (for conspicuity) using lighting, reflectors, and for low-riding units, signal flags on flexible poles.

• Persons with the following conditions shall be cautioned not to operate: Those with heart conditions; Pregnant Women; Persons with head, back, or neck ailments, or prior

• Surgeries to those areas of the body; and persons with any mental or physICal conditions that may make them susceptible to injury or impair their physical dexterity or mental Capabilities to recognize, understand, and perform all of the safety instructions and to be able to assume the hazards inherent in unit use.

• Do not ride at night.

• Do not ride after drinking or taking prescription medication.

• Do not carry items when riding.

• Never operate the product barefooted.

• Always wear shoes and keep shoelaces tied.

• Make sure your feet are always placed securely on the deck.

• Operators always shall use appropriate protective clothing, including but not limited to a helmet, with appropriate certification, and any other equipment recommended by the manufacturer: Always wear protective equipment such as helmet, knee pads, and elbow pads.

• Always give way to pedestrians.

• Be alert to things in front and far away from you.

• Do not allow distractions when riding, such as answering the phone or engaging in any other activities.

• The product cannot be ridden by more than one person.

• When you ride the product along with other riders, always keep a safe distance to avoid a collosion

• When turning, be sure to maintain your balance.

• Riding with improperly adijusted brakes is dangerous and can result in serious injury or death.

• The brake may become hot while operating, do not touch the brake with your bare skin.

• Applying brakes too hard or too suddenly can lock up a wheel, which could cause you to lose control and fal. Sudden or excessive application of the brake may result in injury or deatn.

• If the brake loosens, please adjust with the hexagon wrench, or please contact Jetson

Customer Support

• Replace worn or broken parts immediately.
• Check whether all safety labels are in place and understood before riding.
• The owner shall allow the use and operation of the unit after a demonstration that such operators can understand and operate all components of the unit before use.
• Do not ride without proper training. Do not ride at high speeds, on uneven terrain, or on slopes. Do not perform stunts or turn abruptly.
• Recommended for indoor use.
• Prolonged exposure to UV rays, rain and the elements may damage the enclosure materials, store indoors when not in use.

WARNING
This product can expose you to a chemical such as Cadmium that is known to the state of California to cause cancer or birth defects or other reproductive harm. For more information go to www.p65warnings.ca.gov/product

NOTICE OF COMPLIANCE

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. if this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radiol TV technician for help.

Shielded cables must be used with this unit to ensure compliance with the Class B FCC limits.

Enjoying the ride?
Leave a review on ridejetson.com/reviews or share your photos with us online using the #Ride Jetson hashtag!
Questions? Let us know. support.ridejetson.com
Hours of Operation: 7 Days a Week, 10am-6pm
US 1-888-976-9904 |UK +44 (0)33 0838 2551
Manufactured in Yueyang, China
Imported by Jetson Electric Bikes LLC.
1 Rewe Street, Brooklyn, New York 1211 www.ridejetson.com

CONFIDENTIAL FILE INFORMATION

• DATE: 04/02/2020
• FILE NAME: Force-manual.indd
• FOLDED SIZE: L4.321” H11” | L109.7mm H279.4mm
• UNFOLDED: L17” H11” | L431.8mm H279.4mm
• BLEED: .125” | 3.175mm ON ALL SIDES

PRINTER SPECIFICATIONS

SCALE: 100%
MATERIALS:

• 350g C2S
• Printed double sided: 4C
• 80lbs Matte 96/97 Bright White Art Paper
• Printed double sided

FINISHING/NOTES AND SYMBOLS:
TRIM TO SIZE, SCORE, FOLD and GLUE IN SPECIFIED AREAS. SCORE
FOLDING INSTRUCTIONS:
FOLLOW THE SCORING LINES 8 PANEL ROLL FOLD

DO NOT PRINT COMMENT, SCORING OR DIELINES LAYERS!
Physical sample according to specs must be approved by JETSON BIKE before proceeding to production.
COMMENTS (Internal reference only)
File created by Eitan Adika & Angelina Zavilevich

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>