Jetson JBOLT-BLK Bolt Folding electric ride on User Manual
- June 5, 2024
- Jetson
Table of Contents
Jetson JBOLT-BLK Bolt Folding electric ride on
Safety Warnings
- Before use, please read the user manual and safety warnings carefully, and make sure you understand and accept all the safety instructions. The user will be responsible for any loss or damage caused by improper use.
- Before each cycle of operation, the operator shall perform the preoperation checks specified by the manufacturer: That all guards and pads originally supplied by the manufacturer are in the proper place and in serviceable condition; That the braking system is functioning properly; That any and all axle guards, chain guards, or other covers or guards supplied by the manufacturer are in place and in serviceable condition; That tires are in good condition, inflated properly, and have sufficient tread remaining; The area that the product is to be operated should be safe and suitable for safe operation.
- Components shall be maintained and repaired in accordance with the manufacturer’s specifications and using only the manufacturer’s authorized replacement parts with installation performed by dealers or other skilled persons.
- Don’t allow hands, feet, hair, body parts, clothing, or similar articles to come in contact with moving parts, wheels, or drive train, while the motor is running.
- This product should not be used by children or persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction (IEC 60335-1/A2:2006).
- Unsupervised children should not play with the product (IEC 60335-1/A2:2006).
- Adult supervision is required.
- The rider should not exceed 265 lb.
- Never use near a motor vehicle.
- Units shall not be operated to perform racing, stunt riding, or other maneuvers, which may cause loss of control, or may cause uncontrolled operator/passenger actions or reactions.
- Avoid sharp bumps, drainage grates, and sudden surface changes. The scooter may suddenly stop.
- Avoid streets and surfaces with water, sand, gravel, dirt, leaves, and other debris. Wet weather impairs traction, braking, and visibility.
- Avoid riding around flammable gas, steam, liquid, or dust that could cause fire.
- Operators shall adhere to all of the manufacturer’s recommendations and instructions, as well as comply with all laws and ordinances: Units without headlights shall be operated only with adequate daylight conditions of visibility, and; Owners shall be encouraged to highlight (for conspicuity) using lighting, reflectors, and for low-riding units, signal flags on flexible poles.
- Do not ride at night.
- Only ride the product with adequate daylight conditions for visibility.
- Persons with the following conditions shall be cautioned not to operate: Those with heart conditions; Pregnant women; Persons with head, back, or neck ailments, or prior surgeries to those areas of the body; and persons with any mental or physical conditions that may make them susceptible to injury or impair their physical dexterity or mental capabilities to recognize, understand, and perform all of the safety instructions and to be able to assume the hazards inherent in unit use.
- Do not ride after drinking or taking prescription medication.
- Do not carry items when riding.
- Never operate the product barefooted.
- Always wear shoes and keep shoelaces tied.
- Make sure your feet are always placed securely on the deck.
- Operators always shall use appropriate protective clothing, including but not limited to a helmet, with the appropriate certification, and any other equipment recommended by the manufacturer: Always wear protective equipment such as helmet, knee pads, and elbow pads.
- Always give way to pedestrians.
- Be alert to things in front and far away from you.
- Do not allow distractions when riding, such as answering the phone or engaging in any other activities.
- The product cannot be ridden by more than one person.
- When you ride the product along with other riders, always keep a safe distance to avoid a collision.
- When turning, be sure to maintain your balance.
- Riding with improperly adjusted brakes is dangerous and can result in serious injury or death.
- Applying brakes too hard or too suddenly can lock up a wheel, which could cause you to lose control and fall. Sudden or excessive application of the brake may result in injury or death.
- The brake may become hot while operating, do not touch the brake with your bare skin.
- If the brake loosens, please adjust with the hexagon wrench, or please contact the Jetson Care Team.
- Replace worn or broken parts immediately.
- The area where the product is to be operated should be safe and suitable for safe operation.
- Check whether all safety labels are in place and understood before riding.
- The owner shall allow the use and operation of the unit after a demonstration that such operators can understand and operate all components of the unit before use.
- Recommended for indoor use.
- Use caution when charging. Do not operate chargers near flammable materials. Unplug the charger and disconnect from the scooter when not in use.
- When the battery is fully charged, stop charging and unplug the unit.
- Prolonged exposure to UV rays, rain and the elements may damage the enclosure materials, store indoors when not in use.
WARNING:
This product can expose you to the chemical Cadmium, which is known to the
State of California to cause cancer and birth defects or other reproductive
harm. For more information, go to
www.P65Warnings.ca.gov.
MODIFICATIONS
Do not attempt to disassemble, modify, repair, or replace the product or any
components of the unit without instruction from the Jetson Care Team. This
will void any warranty and can lead to malfunctions that may cause injury.
ADDITIONAL OPERATION CAUTIONS
Do not lift the product off the ground while it is on and the wheels are in
motion. This can result in freely spinning wheels, which may cause injury to
yourself or others nearby. Do not jump on or off the product, and do not jump
while using it. Always keep your feet firmly planted on the mat sensors while
in operation. Always check the battery charge before using.
Product Overview
- Front Tire
- Headlight
- Stem Quick Release
- Handbrake
- Handlebar
- Carrying Handle
- Seat
- Seat Clamp
- Taillight
- Rear Fender
- Rear Disc Brake
- Rear Tire
- Kickstand
- Foot Rest
- Front Fender
- Charging Cable
- Charger
-
Tools & Hardware
Nuts × 1 pre-attached -
Bolt × 1 pre-attached
-
2-bit Phillips head screwdriver and Allen key tool × 1
CAUTION : Before operating the Bolt, tighten all screws, nuts, and bolts.
Specs & Features
- Product Dimensions: 40 in × 19.2 in × 37 in
- Weight Limit: 265 lbs
- Product Weight: 34 lbs
- Tire Size: 12 in
- Speed: Up to 15.5 mph
- Range: Up to 15 miles
- Battery: 36V, 6.0Ah Lithium-Ion
- Motor: 250W
- Charger: 100-240V
- Charge Time: Up To 5 Hours
- Climbing Angle: Up To 15°
- Recommended Age: 13+
Getting Started
Attaching the Seat
Open the Seat Clamp lever and loosen the knob to widen the Clamp opening.
Slide Seat Post into Stem Tube.
Turn the knob clockwise to tighten the Seat Clamp. Close the Seat Clamp.
Attaching the Foot Rests
Slide one Foot Rest onto each side of the Axle. Twist Foot Rests clockwise to
tighten and secure.
Attaching the Rear Fender
Remove pre-attached bolt and nut from the frame above the Rear Wheel. Place
Rear Fender in position so that the pre-drilled hole in the Fender is aligned
with the hole in the frame. Slide the bolt through the Fender and frame, and
tighten the bolt using the screwdriver tip of the tool.
Charging the Battery
Important:
- Use only the included Charger.
- Plug the Charger into the wall outlet before plugging into the Charging Port.
- Do not turn on the Bolt while it’s charging.
- Charge the battery until it is fully charged – up to 5 hours.
- Replace the cover over the Charging Port when done.
- Never leave the Bolt charging overnight
Charging Indicator Light on the Charger:
- Red Light : Battery is charging
- Green Light : Charging is complete
Unfolding the Handlebar
Slowly lift the Handlebar up.
Press the Stem Quick Release in to locked/closed position. To fold the Handlebar, open/unlock the Stem Quick Release and slowly lower the Handlebar down. Rotate the Stem Clamp lock clockwise to secure the Stem Quick Release.
Make Moves
Operating the Bolt
- Power Button : Press to turn the Bolt on or off.
- Light Switch : Push the switch up to turn the headlight and taillight on. Push it down to turn the lights off.
- Cruise Control Button : Press when you have reached the speed you would like to maintain. Apply the brake to deactivate Cruise Control.
Battery charge as indicated by Battery Indicator Screen:
- 4 Lights: 76-100% Power
- 3 Lights: 51-75% Power
- 2 Lights: 26-50% Power
- 1 Light: 1-25% Power (Charge the Bolt immediately!)
Helmet Safety
Wear a helmet, appropriate clothing, shoes, and safety gear. Avoid clothing that can get caught into or under the wheels. Closed-toe, flat shoes are recommended. Wear an ASTM F1492 approved helmet and protective gear to prevent injury in the event of an accident
Riding the Bolt
Before each ride, check that the Handlebar and Seat are secure, the tire
pressure is 35-40 PSI, and the brake system works correctly. Keep your feet on
the Foot Rests. Do not ride with your feet dangling over the sides. Always
stay seated while riding
Care & Maintenance
Maximizing Riding Range
The maximum range is 24.1 km / 15 miles. However, a lot of factors will affect
how far you can go per battery charge:
- Riding Surface: A smooth, flat surface will increase riding distance.
- Weight: More weight means less distance.
- Temperature: Ride the Bolt above 10°C / 50°F.
- Maintenance: Charging the battery after every ride will increase riding distance.
- Speed and Riding Style: Frequent starting and stopping will reduce riding distance.
Cleaning The Bolt
To clean the Bolt, carefully wipe with a damp cloth, then dry with a dry
cloth. Do not apply water directly onto the Bolt, as the electrical systems
and electronics may get wet, which could result in a malfunction that leads to
personal injury.
Battery Safety Measures
- Keep the Bolt away from fire and excessive heat.
- Do not subject the Bolt to intense physical shock, severe vibration, or impact.
- Protect from water or moisture.
- Do not disassemble the Bolt or its battery.
- If there are any issues with the battery, please contact the Jetson Care Team.
Storing the Bolt
- Fully charge the battery before storing.
- The battery should be fully charged once a month during extended periods without use.
- To protect against dust, cover the Bolt.
- Store the Bolt indoors, in a dry place, and at a temperature above 10°C / 50°F.
Stay connected.
Be sure to follow @ridejetson on social media to learn about fantastic offers,
giveaways, and all the latest Jetson news
Questions? Let us know.
ridejetson.com/support ridejetson.com/chat
To exercise your product’s 1-year limited
warranty or inquire about warranty coverage, contact us directly. US/CANADA:
1-888-976-9904 MEX: +001 888 976 9904
UK: +44 (0)33 0838 2551 Hours of Operation: 7 Days a Week, 10am-6pm EST
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>