Karibu Garden house Maltas 2 209 x 213 cm natural Instructions
- June 4, 2024
- Karibu
Table of Contents
Garden house Maltas 2 209 x 213 cm natural
31212 31211
Das komplette Farbangebot finden Sie auf: www.KARIBU- FARBENSHOP.de
Building Instructions
|
---|---
First compare the list of materials with your package contents! Please understand that complaints can be processed in the non-built status only!
Overview
Not included
- Length must be determined and sawn
|
---|--- - Not needed
- with accessories!
- Fixed temporarily
- Inventory of accessories
Werkzeuge / Tools*
|
---|---
Glue! Look for the same height
Dear customer, pay attention to the correct design variant!
Roofing felt installation
Note! This description is only an example!
The number of bitumen strips to be used depends on your actual house size.
When joining rolls of roofing felt end to end, the overlap must be
approximately 10cm. The roof is not safe to walk on. The roof is designed for
a total load (snow, wind) and not for a point load. We recommend you to always
support the roof from below during installation. The sealing of the roof
surfaces to adjacent components with bitumen sealant has to be effected by the
customer! If it is a saddle-roofed house, do not use roofing tiles for
roofing. In this case, a 20 cm wide strip of bitumen with overhang should be
installed on both sides of the eaves. For houses with a tonne roof, please
install a bitumen roofing under the shingles. In the case of a flat roof the
laying of roof shingles is not possible!
floor
Installation door
Handling • Maintenance • Care of the door
The guarantee is conditional on proper upkeep!
For lasting protection of the value and suitability for use, professional care
and maintenance is also recommended during the warranty period; this is not
included in the warranty obligations. Defects must be repaired immediately
upon detection.
Wood protection treatment of the door
All parts of the door must receive wood protection treatment. Those sections
of the wood, which will not be accessible after installation, should receive
complete treatment before installation.
Treat the product with a blue stain-blocking coat; afterward apply a double
protective coating of an open-pored wood-protection glaze. Application of a
protective coating should be repeated at least every two years. Please beware
that the inserted plates of other material may come to differ in colour to the
doors if you use unsuitable coating material. With coloured and boiler
pressure-impregnated houses, only the exposed natural wood (saw cuts) and
parts should need extra treatment.
You can obtain an even colour covering in inside areas with one coat of paint.
For that, you should use an open-pored, acrylic-based water-dispersed lacquer.
In order to guarantee a long service life of your product you should repair
damaged areas immediately. Do this by whetting the damaged area and apply a
new coat of paint. Enquire about suitable glazes at your local paint retailer.
Furthermore, you can seal the joining of the wood-window pane with a suitable
sealant to guarantee a long service life of the door and prevent leakage from
heavy rain. If these precautions of care are not properly carried out, it can
result in deformation, blue stain, fungus infestation in the doors and frames
and loss of warranty.
Cleaning
Regular cleaning and care is a prerequisite for preserving the service life
and functionality of high-value products. Cleaning is to take place outside,
inside and also in the rabbet-area. The cleaning agent used must be suitable
for the relevant material; please do a test before you start cleaning.
Deformation of the door
Wood reacts to environmental infl uences. Weather exposure will lead to
swelling and contraction of the wood. This causes variances of dimensions and
slight deformation. Dependant on the weather exposure, the door may need
realignment by turning the hinges in- or outwards. Some door warpage is
acceptable as long as the door can be made to function through the alignment
options specifi ed here. The warranty does not cover damage caused by use of
excessive force.
Adjustment of the door
The door must be accurately adjusted to ensure trouble-free operation. The
door frames must be installed right-angled and perpendicular. Furthermore,
they must be installed so the width of the frame is the same at the top and
bottom. If the door doesn’t close or if one panel is askew, this can be rectifi
ed by limited in- or outward turning of the hinges. You can turn the hinges
outwards up to 5 rotations. If you have a double door, the door to be secured
must always be correctly aligned at the top and bottom with the appropriate
hinges.
Karibu Holztechnik GmbH ● Eduard-Suling-Str. 17 ● 28217 Bremen info@karibu.de
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>