HYUNDAI KR 615 AM-FM Kitchen Alarm Clock Radio Instruction Manual

June 5, 2024
HYUNDAI

HYUNDAI KR 615 AM-FM Kitchen Alarm Clock Radio

FOR HOUSEHOLD AND INDOOR USE ONLy
Please read these instructions before use and retain for future reference.

LOCATION OF CONTROLS

  1. LED Digital Clock Display
  2. Volume Control – Buzz On/Off
  3. Tuning Control
  4. Waveband Selector
  5. Snooze Control
  6. Alarm Set Button
  7. Time Set Button
  8. Countdown On/Off Button
  9. Minute Set Button
  10. Hour Set Button
  11. Function Selector
  12. FM Antenna
  13. Auto Indicator
  14. Battery Door
  15. Desktop Stand
  16. Mounting Plate

MOUNTING THE SET

  1. Remove the mounting plate from the radio by pushing the mounting plate backward.
  2. Use screws provided to fix the mounting plate under a cabinet.
  3. Insert the mounting plate into the top panel of the radio (A) and push the radio backward (B) until it is locked securely.
  4. Set the Function Selector (11) and Countdown On/Off Button (8) to “OFF”. Connect the AC power cord to the wall socket. This switches on the power supply.

IMPORTANT!

  • Never plug in the AC power cord to the power outlet before installation is completed.
  • Install your set near the AC outlet and where the AC power plug can be reached easily.
  • Do not use a converter or extension cord.
  • Install the set as far as possible from sources of interference, such as a refrigerator, microwave oven, fluorescent lamp, etc.
  • There should be at least 6,5 cm distance between the unit and the wall.
  • To reduce the risk of fire, do not place any heating or cooking appliance beneath the set.

REAL TIME SETTING

  1. After the AC power cord connected, the clock display will flash on and off indicating a power interruption and that the displayed time is incorrect.
  2. To set the correct time, press the Time Set Button (7) and simultaneously press the Hour Set Button (10), or Minute Set Button (9), together, until the correct time is displayed. (Please note that Countdown On/Off Button (8) must be set to”OFF” position.)
  3. Open the clock Battery Door (14) at the bottom of the unit and put in a 6LR61/6F22 (or equivalent) 9-volt battery. The purpose of this battery is to store the information relating to alarm time and to keep the clock functioning in the event of disconnection from the mains supply or power interruption. Should this occur, the clock would continue to keep time, but will not display.

PLEASE NOTE: When operating from battery only, the clock will only remain accurate for a short period of time. It is important that the mains supply is restored as soon as possible.

ALARM TIME SETTING

  1. Press the Alarm Set Button (6) and simultaneously press the Hour Set Button (10) or Minute Set Button (9) as appropriate until the required alarm time is reached.
  2. To double check the alarm time, simply press the Alarm Set Button (6) then the display will show the pre-set alarm time.

RADIO OPERATION

For AM reception this unit uses an internal directional aerial, rotate the unit for best reception. For FM reception, the wire FM Antenna (12) on the back of the unit should be fully unwound.

  1. Set the Function Selector (11) to the “ON” position.
  2. Set the Waveband Selector (4) to the required waveband.
  3. Use the Tuning Control (3) to select the desired station.
  4. Adjust the Volume Control (2) to the desired listening level.
  5. To turn off the radio, set the Function Selector (11) to “OFF”.

WAKE TO RADIO
Having selected your desired station and adjusted the desired listening level, proceed as follows:

  1. Follow the instructions for “ALARM TIME SETTING” above.
  2. When the desired alarm time has been selected, set the Function Selector (11) to the “AUTO” position.
  3. The radio will switch on automatically at the pre-set alarm time.
  4. The alarm can be temporarily stopped for approximate 9 minutes by pressing the Snooze Button (5) once.
  5. Press the Alarm Set Button (6) to turn off the radio. The alarm will activate again after 24 hours unless the Function Selector (11) is set to “OFF”.

WAKE TO BUZZER

  1. Follow the instructions for “ALARM TIME SETTING” above.
  2. When the desired alarm time has been selected, set the Function Selector (11) to the “AUTO” position.
  3. Turn the Volume Control – Buzz On/Off (2) fully anti-clockwise to select the BUZZ function.
  4. The alarm tone will switch on automatically at the pre-set alarm time.
  5. The alarm can be temporarily stopped for approximate 9 minutes by pressing the Snooze Button (5) once.
  6. Press the Alarm Set Button (6) to turn off the buzzer. The alarm will activate again after 24 hours unless the Function Selector (11) is set to “OFF”.

SET THE COUNTDOWN TIMER
The countdown alarm can be adjusted from 1 minute to 1 hour and 59 minutes.

  1. Set the Function Selector (11) to either “ON” or “OFF” position.
  2. Slide the Countdown On/Off Button (8) to “ON” position.
  3. Adjust the desired time by pressing the Hour Set Button (10) or Minute Set Button (9) as appropriate until the required timer period is reached.
  4. The timer starts to count down and the alarm sounds when the required timer period is reached.
  5. To turn off the countdown timer, slide the Countdown On/Off Button (8) to “OFF” position.

CLEANING

Clean the cabinet with a soft cloth moistened with water or mild detergent. Do not use solvents such as alcohol, benzene or thinner, as they may damage the cabinet finish. Make sure to disconnect the mains lead from the supply before cleaning.

CAUTION

  1. Ensure minimum distances around the apparatus for sufficient ventilation. The ventilation should not be impeded by covering the ventilation openings with items, such as newspa-pers, table-cloths, curtains, etc.
  2. No naked flame sources, such as lighted candles, should be placed on the apparatus.
  3. It shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus.
  4. Do not place the product in closed bookcases or racks without proper ventilation.
  5. Where the mains plug is used as the disconnect device, the disconnect device shall remain readily operable.
  6. Attention should be drawn to the environmental aspects of battery disposal.
  7. The use of apparatus in moderate climates.
  8. Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
  9. The batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like.

SPECIFICATION

  • Power Source: AC 230 V ~ 50 Hz
  • Frequency Range: AM 530 – 1600 kHz FM 88 – 108 MHz
  • Battery (for Clock Back-up): 1 x 9 V Battery Size 6LR61 / 6F22 or equivalent (not included)
  • Supplied Accessories: 1 x Mounting Plate, 4 x screws
  • Dimensions: 205x75x130 mm
  • Weight (NET):  540 g

Marking plate is located on the top panel of the apparatus. We reserve the right to change technical specification.
WARNING: Do not use this product near water, in wet areas to avoid fire or injury of electric current. Always turn off the product when you don’t use it or before a revision. There aren’t any parts in this appliance which are repairable by consumer. Always appeal to a qualified authorized service. The product is under a dangerous tention.

Old electrical appliances, used batteries and accumulators disposal

This symbol appearing on the product, on the product accessories or on the product packing means that the product must not be disposed as household waste. When the product / battery durability is over, please, deliver the product or battery (if it is enclosed) to the respective collection point, where the electrical appliances or batteries will be recycled. The places, where the used electrical appliances are collected, exist in the European Union and in other European countries as well. By proper disposal of the product you can prevent negative impact on environment and human health, which might otherwise occur as
a consequence of improper manipulation with the product or battery / accumulator. Recycling of materials contributes to protection of natural resources. Therefore, please, do not throw the old electrical appliances and batteries / accumulators in the household waste. Information, where it is possible to leave the old electrical appliances for free, is provided at your local authority, at the store where you have bought the product. Information, where you can leave the batteries and accumulators for free, is provided to you at the store, at your local authority.

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals