baby trend ST14 A Rocket PLUS Lightweight Stroller Instruction Manual

baby trend ST14 A Rocket PLUS Lightweight Stroller

PARTS

Check that you have all the parts for this model before assembling the stroller. Verifique que tenga todas las piezas para este modelo antes de montar el carrito.

ASSEMBLY

FRAME SETUP
Remove stroller from box. The front wheels and rear wheels MUST be installed prior to use.

Unlock the release lever (Fig. 1a).

• Pull back on the handlebars to open the stroller frame (Fig. 1b).
• Push the center pedal down completely to lock the stroller open (Fig. 1c).
• Destrabe la palanca de liberación (Fig. 1a).
• Tire las barras del manubrio hacia atrás para abrir el armazón del carrito (Fig. 1b).
• Empuje el pedal del centro hacia abajo completamente para bloquear el cochecito abierto (Fig. 1c).

FRONT WHEELS

Lean the stroller backward and push each front wheel posts into the wheel housing (Fig. 2a). Press firmly to lock each wheel into position.

NOTE:
Pull on each wheel to ensure they are both securely attached.

REAR WHEELS

• To attach the rear wheels, lean the stroller forward so that the rear legs are pointing upward (Fig. 3a).
• Position the rear wheels over the rear leg tubes so that the hole in the housing lines up and will slide into the legs (Fig. 3b). Firmly push down until the wheels lock securely into place.

NOTE:
Pull on each wheel to ensure they are both securely attached.

CANOPY

• Insert the canopy into the frame connection (Fig. 4a).
• To open the canopy: Push forward on the front edge of the canopy. Press downward on the canopy locks to secure (Fig. 4b). • To fold the canopy: Pull upward on the canopy locks and then pull backward on the front edge of the canopy (Fig. 4c).
• To remove the canopy: Locate both side connectors. For the canopy, press both canopy clips back to remove (Fig. 4d).

PARENT TRAY

WARNING:
TO AVOID BURNS, NEVER PUT HOT LIQUIDS IN THIS TRAY. AVOID POSSIBLE TIPPING, DO NOT PLACE MORE THAN 2 LBS ON THIS TRAY.

SAFETY

BRAKES

WARNING:
Always set brakes when the stroller is not being pushed so that the stroller will not roll away. NEVER leave the stroller unattended on a hill or incline as the stroller may slide down the hill.

FRONT-WHEEL SWIVEL:
To lock the swivel feature, gently lift up on the levers (Fig. 5a). To release and engage the swivel, apply downward pressure to the levers (Fig. 5b).

REAR BRAKES:
To engage brakes, apply downward pressure to the brake levers. The stroller may require forward or rearward movement in order to engage the brake (Fig. 6a). Check that the stroller will not move once the brakes are properly applied. To release, gently lift up on the brake levers (Fig. 6b).

TO SECURE THE CHILD

WARNING:
Avoid serious injury from falling or sliding out. Always use the safety harness.

STRANGULATION HAZARD:
A child can strangle in loose straps. Never leave a child in the seat when straps are loose or undone.

• The shoulder straps of the 5-point harness have 3 attachment positions. Select the position that places the shoulder strap level with, or below, the top of the child’s shoulders.
• To adjust harness height unhook the shoulder strap from the crotch buckle. Feed the shoulder strap through the harness spread slots (Fig. 7a). You can access these slots from the rear of the seat. Feed shoulder strap through the appropriate slot and reattach shoulder strap to crotch buckle.
• Carefully place the child in the stroller seat and bring the safety harness around the child’s waist and over the shoulders. Place the crotch strap between the child’s legs. Insert the male end of each shoulder/waist belt into the buckle on the crotch strap. Tighten the harness to be snug around the child’s waist and over the child’s shoulders (Fig. 7b).

TO RELEASE THE CHILD
To release, push the Button on Center Clasp, the two Harness Buckles will pop free (Fig. 8).

SEAT BACK POSITION
To recline the seat press the clip ends together to release and pull down (Fig. 9a). To place seat into an upright position, press the clip ends together while holding the end of strap. Push clip upwards to secure into the desired position (Fig. 9b). The upright position should be used only for a child that is at least 6 months old. Always re-adjust the safety harness, including the shoulder belts, when repositioning the seatback.

FOLD

TO FOLD STROLLER

WARNING:
Care must be taken when folding the stroller to prevent finger entrapment.

CAUTION:
Do not allow children near stroller while folding.

• Close the canopy as described in the canopy section (Fig. 4c).
• To release the lock, pull the center pedal from the right side tab towards you and push up, push the left side tab away from you and push up. Then pull the center pedal upward. The released pedal will begin to fold together simultaneously with the stroller frame (Fig. 10a).
• Push the handles forward until the stroller completely closes (Fig. 10b).
• Lock the release lever to secure the stroller (Fig. 10c).
• Cierre la cubierta como se describe en la sección de la cubierta (Fig 4c).

MAINTENANCE

FRONT-WHEEL REMOVAL

• Push the tab located underneath the wheel hub. Pull the wheel out from the hub (Fig. 11).
• Empuje la pestaña ubicada debajo del cubo de la rueda. Saque la rueda del buje (Fig. 11).

REAR WHEEL REMOVAL

• To remove the rear wheel, press the pins and pull off the rear wheel (Fig. 12). Repeat for the other side.

If replacement is needed:

• For removal, refer to step 4d.
• To attach the canopy: Slide both canopy’s ends onto the plastic tab of the stroller frame (Fig. 13).

NOTE:
Ensure the canopy is completely snapped into position.

If replacement is needed:
To remove, unsnap the buttons. Re-attach the parent tray to the frame by wrapping the ends of the parent tray over the handles of the frame and snap the buttons from the frame and parent tray together (Fig. 14).

CARE AND MAINTENANCE

• Cleaning Seat Pad: Spot clean only – Surface wash small spots with a mild solution of soap and water. Rinse with water to remove the soap solution. Wipe or air dry.
• Cleaning Stroller: Surface wash stroller frame, plastic parts, and fabric with a mild solution of soap and water. Wipe surfaces with water to remove soap solution. Wipe or air dry.
• Cleaning Parent Tray: Spot clean only – Surface washes small spots with a mild solution of soap and water. Rinse with water to remove the soap solution. Wipe or air dry.
• Check your stroller for loose screws, worn parts, torn material, or stitching on a regular basis. Replace or repair parts as needed.

WARRANTY

DO NOT RETURN YOUR PRODUCT TO THE STORE. PLEASE CONTACT BABY TREND® FOR REPLACEMENT PARTS, SERVICE AND REPAIR.

The Baby Trend® warranty covers workmanship defects within 1 year of purchase. Any product which has been subjected to misuse, abuse, abnormal use, excessive wear and tear, improper assembly, negligence, environmental exposure, alteration or accident, or has had its serial number altered or removed invalidates all claims against the manufacturer. Any damage to property during installation is the sole responsibility of the end user.

Customer Service Department can be contacted at 1 800-328-7363 Monday through Friday between 8:00 a.m. and 4:30 p.m. (PST). Return Authorizations are required prior to returning product(s) to Baby Trend®. Please visit http://babytrend.com/pages/limited-warranty for complete warranty details.

WARNING

• Please follow all of these instructions to ensure the safety of your child. Keep these instructions for future reference.
• Failure to follow these instructions could result in serious injury or death. Avoid serious injury from falling or sliding out, always use the safety harness and ensure that the children are properly positioned according to these instructions.
• Never leave children unattended.
• Care must be taken when folding and unfolding the stroller to prevent finger entrapment.

CAUTION:

• This stroller is designed for one child only. Use with more than one child may cause an unbalanced condition which can injure/harm your child.
• Purses, shopping bags, parcels, diaper bags or accessory items may change the balance of the stroller and cause a hazardous, unstable condition.
• The maximum weight that can be carried in the storage basket is 5 lb (2.26 kg). Parent tray is 2 lbs (0.9 kg). Excessive weight may cause a hazardous unstable condition to exist. Do not place hot liquids in the parent tray. Serious burns or unstable conditions could result.
• Be certain the stroller is completely opened and locked in place before allowing a child near the stroller.
• The maximum weight capacity of this stroller is up to 50 lbs (22.5 kg) or 40 inches (101.6 cm). Additional weight will cause excessive wear and stress on the stroller and may cause a hazardous unstable condition to exist.
• NEVER use the stroller on stairways or escalators.
• NEVER use the stroller with roller skates, in-line skates, skateboards or bicycles.
• NEVER allow your stroller to be used as a toy.
• To clean use only mild household soap or detergent and warm water on a sponge or clean cloth.
• Check your stroller for loose screws, worn parts, torn material or stitching on a regular basis. Replace or repair parts as needed.
• Discontinue use of the stroller should it malfunction or become damaged.

WARNING

IMPORTANT

• To ensure the safe operation of your stroller, please follow these instructions carefully. Please keep these instructions for future reference.
• Before assembly and each use, inspect this product for damaged hardware, loose joints, and missing parts.

BABY TREND® CUSTOMER SERVICE
The Customer Service Department can be contacted at 1 800-328-7363 Monday through Friday between 8:00 a.m. and 4:30 p.m. (PST). Return Authorizations are required prior to returning product(s) to Baby Trend®.

References

• Limited Warranty Coverage – Baby Trend
• Baby Trend® | Car Seats, Strollers, High Chairs, Nursery and More!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>