AUO ADP-0350-H Panel PC with Touch Screen User Guide

: June 5, 2024
: AUO

Table of Contents

AUO ADP-0350-H Panel PC with Touch Screen
Contents
Indication
Installation
- Cable Connection
FCC STATEMENT
Read User Manual Online (PDF format)
Download This Manual (PDF format)

AUO ADP-0350-H Panel PC with Touch Screen

AUO-ADP-0350-H-Panel-PC-with-Touch-Screen-PRODUCT

Indication

AUO-ADP-0350-H-Panel-PC-with-Touch-Screen-FIG-2

Reset Button
ADB
DC 5V IN
USB
Speaker
Touch screen
LED indicator light
NFC
Microphone
Bracket

Installation

Cable Connection

AUO-ADP-0350-H-Panel-PC-with-Touch-Screen-
FIG-3

Step 1: Plug USB cables into USB ports.
Step 2: Fix the screws to secure the USB cables.

Surface Bracket Mount Installation

AUO-ADP-0350-H-Panel-PC-with-Touch-Screen-FIG-5

Install the bracket on surface

Screw specifications: KA4*14,
Diameter: 7 mm (Screws are not provided)
Assemble the panel PC to the bracket.
Tighten the screws. Locations are shown in the above illustration.
Black screws are provided in the screw pack.
Cover the screws with rubber caps.

Adhesive Bracket Mount Installation

AUO-ADP-0350-H-Panel-PC-with-Touch-Screen-FIG-43

Laminate adhesive to the back of the bracket.
Install the bracket onto the panel PC bracketslot (at the back).
Tighten the screws and cover them with rubber caps.
Black screws are provided in the screw pack.
Peel off the adhesive and attach the panel PC to a smooth and clean surface.

Please install and use this product in strict accordance with the instructions.

FCC STATEMENT

WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/panel PC technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

this device may not cause harmful interference.
this device must accept any interference received, including interference that may cause undesired operation.

Correct Disposal of this product. This marking indicates that this product should not be disposed of with other household wastes throughout the EU. To prevent possible harm to the environment or] human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmentally safe recycling. ″FCC & CE RF Radiation Exposure Statement Caution: To maintain compliance with the FCC & CE′s RF exposure guidelines, place the product at least 20cm from nearby persons.″

Declaration of Conformity

This device complies with the requirements set out in the Council Directive on the Approximation of the] Laws of the Member States relating to Electromagnetic Compatibility (2014/30/EU), Low-voltage] Directive (2014/35/EU), ErP Directive (2009/125/EC), RoHS directive (2011/65/EU) and Radio Equipment] Directive (2014/53/EU).] This product has been tested and found to comply with the harmonized standards for Information Technology Equipment, these harmonized standards are published under Directives of the Official Journal of the European Union.

Adaptor with ferrite must be used with this equipment to ensure compliance with the Class B FCC limits. Specifications of the DC power adapter