HYUNDAI HC 802 Hair Clipper Instruction Manual

**HYUNDAI HC 802 Hair Clipper Instruction Manual

**

Dear customer, thank you for purchasing our product. Please read the operating instructions carefully before putting the appliance into operation and keep these instructions including the warranty, the receipt and, if possible, the box with the internal packing

SAFETY WARNING

• Before the first use, read the instructions for use carefully, look at the picture and keep the instructions for use. Consider the instructions for use as a part of the appliance and pass them on to any other user of the appliance.
• Check whether the data on the type label correspond with the voltage in your socket.
• Never use the appliance if it does not work properly, if it fell down and was damaged or if it fell to water.
• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. Children younger than 8 years must be kept out of reach of the appliance and its power cord.
• Before replacing accessories or accessible parts, which move during operation, before assembly and disassembly, before cleaning or maintenance, turn off the appliance and disconnect it from the mains by pulling the power cord from the power socket!
• Do not leave the appliance plugged in power supply without supervision!
• If the power cord of the appliance is corrupted, it has to be replaced by the producer, its service technician or a similarly qualified person so as to prevent dangerous situations.
• Never use the appliance if its power cord or plug is damaged, if it does not work properly, if it fell down and was damaged or if it fell into water. In this case, take the appliance to a special service to check its safety and proper function.
• For additional protection we recommend installation of current protection (RCD) with the nominal release current not exceeding 30 mA. Ask a control technician or an electrician for advice.
• After finishing work and before cleaning, always switch off the appliance and disconnect it from power supply by taking the power cord connector out of the electric socket.
• The appliance is intended for use in households only and for similar use! It is not designed for use in hair salons or for other commercial use!
• Do not put or take out the plug to or from a socket with wet hands!
• Do not let the appliance in operation without supervision!
• Never immerse the appliance in water or other liquids (even partially) and do not clean it in running water!
• Use only the accessories designed for this type. Do not use damaged adapters.
• Never tuck the appliance or the accessories into any body holes.
• Be careful in using the appliance without a set adapter, the blades   are sharp.
• The appliance is not intended for styling animal hairs.
• Do not use the appliance while having a bath, having a shower or taking a sauna and for trimming wet or artificial hair.
• Do not put the trimmer on hot heat sources (e. g. oven, stove, radiator, etc.)
• The trimmer must not be used at places where it could fall into a bath tub, a wash basin or a swimming pool. If the dryer fell to water anyway, do not take it out! First of all, unplug the supply cord from the socket and only then remove the trimmer. In this case take the appliance to a special service to check its safety and proper function.
• In case the cutting lath or one of the cutting attachments gets blocked, the appliance must be turned off immediately and the cause removed.
• Check regularly, if the blades are not damaged or deformed. – Do not attempt to repair the appliance yourself.
• It is not allowed to alter the surface of the appliance in any way (e.g. sticker, foil etc.)!
• Also, do not put the trimmer in the on position on soft surfaces (e. g. bed, towels, sheets, carpet); the surfaces or the appliance could get damaged.
• If the dryer was stored at lower temperatures, acclimatize it first, by which you remove stiffness of the lubricating fat in bearings and mechanical resistance of the plastic parts will be maintained.
• The power cord must not be damaged with sharp or hot objects, open fire and it must not be sunk into water or bent over sharp edges.
• Make sure that the power cord does not hang over the edge of the working table where children could reach it.
• If you need to use the extension cord, it has to be uncorrupted and it has to comply with the valid standards.
• Turn off the appliance immediately, let it cool down and store it at a dry place, out of reach of children and incapacitated people.
• Never use the appliance for any other purpose than for the intended purpose described in these instructions for use!
• The appliance cannot be in continuous operation for longer than 10 minutes. After this time, turn it off and let it rest.
• Do not wind the power cord around the appliance, this will extend life of the power cord.
• Oil: Warning, Avoid contact with eyes, Do not drink! Keep the special oil bundled with the device out of reach of children, persons insane. Heed the instructions written on the package when handling!
• The producer is not responsible for any loss caused by improper handling of the appliance and its accessories (e. g. injury, appliance damage, fire, etc.) and its guarantee for the appliance does not apply in the case of non-compliance with the safety instructions above.

FEATURES OF THE DEVICE AND ACCESSORIES (pic. 1)

• A – trimmer
  • A1 – ON/OFF switch
  • A2 – haircut length lever
  • A3 – blades cover
  • A4 – cutting blades
  • A5 – supply cord
  • A6 – supply cord loop
• B – attachments
  • B1 – hair length approx. 3 mm
  • B2 – hair length approx. 6 mm
  • B3 – hair length approx. 9 mm
  • B4 – hair length approx. 13 mm
• C – accessory
  • C1 – brush
  • C2 – oil
  • C3 – comb

INSTRUCTIONS FOR USE

Use

We recommend oiling the blades with the oil attached. You may use the appliance without attachment – for trimming contours or with a selected attachment B according to a desired hairstyle length. Put the attachment on the head of the appliance, so that it locks in place. Proceed reversely when taking the attachments off. Wash, dry and brush your hair with a brush before trimming. Turn the appliance on with the switch A1. Hold the appliance with ease so that you can control it perfectly. Trim off only little bits of hair first to get used to the length of hair which the attachment offers. For an even haircut never go through the hair fast. The clippers work best at their own pace. Turn the clippers off with the switch A1  after finishing.

Cutting hair with the use of the attachments

1. We recommend first trying the attachment B4 and only then, if you wish for a shorter cut, use the attachment B1, B2, B3. Always turn the clippers with a switch A1 before changing the attachments.
2.  Comb the hair in the direction of its natural growth.
3. Start cutting by shortening the hair on the sides from below to the top. Guide the trimmer slowly against the hair with the adapter leading upwards, but flatwise along the head. Lift up the appliance slowly and offward head. Cut only small volume of hair in each stroke.
4. Repeat step 3 on the sides and on the back around the whole head.
5. Start trimming hair on the top of the head from front to the back with the adapter teeth held along the head. In the first couple of trimmings it is recommended to leave hair longer.

Cutting contours

1. No adapter is used for aligning contours.
2. Comb the hair in the required style.
3. Set the trimmer between hairline and ear. Check whether the corner of the trimmer blades is set against hairline. Follow the hairline and go round the ear slowly with the trimmer upwards and to the back. Do not push on the trimmer.
4. At the back on the neck and by the sideburns, hold the appliance against the skin and go down at the required length.

Note:
When using the device without attachment, you can change the haircut length with the lever A2. The length range in this case is approx. 2 – 5 mm.

Short military cut

1. Always cut from the scruff to the head top using the longest setting.
   Hold the trimmer flatwise along the head and move it slowly through the hair upwards. Apply the same procedure on the head sides; even here move the trimmer bottom-up.

2. On the front part of the head top, cut the hair against the growth direction. Then align the cut against the cut on the temples.

3. If you want to reach even cut on the top, cut the hair using a straight comb, not the trimmer adapter. Use the comb for cutting hair on the top of the head.

4. To shorten the cut towards the neck, gradually use shorter adapters. Comb through the hair and look for unevenness in the cut. Align the cut by the neck and at the ears.

5. If you want to reach graduated short cut along the sides of the head and on the neck, follow the instructions on fig. 3.The mentioned main areas on the figure are your map for becoming an amateur barber easily.

Trimming beard

1. Before trimming beard, wet it a bit and comb it.
2. Mark the beard line using the trimmer and cut out the beard exceeding the line on the outside.
3. If you want to reach even beard cut, use one of the B adapters or trim the ends carefully in parts using a comb by moving the comb through the beard upwards (fig. 2A). Repeat the process on the whole beard.
4. After the end of trimming, shave the area around the beard in a usual way.

Trimming moustache

1. Before trimming moustache, wet it a bit and comb it.
2. For reaching even cut of the moustache, cut the ends carefully through a comb. If you prefer using a finger as the guide, follow the procedure on figure 2B.

MAINTENANCE

Turn off the appliance before each maintenance, unplug the power cord from the power supply! Do not use rough and aggressive detergents! Wipe the trimmer surface with a wet soft cloth.

Cleaning blades
Clean the blades with an enclosed brush.In order to keep the trimmer in a perfect condition, you have to lubricate the list with blades using one or two drops of oil for sewing machines. Do not use hair oil, petroleum jelly or oil mixed with petrol or any other solvent because after evaporation the solid parts of the lubricant could slow down operation of the blades. Insert the trimming head to the trimmer properly, turn on the trimmer and then turn it off and wipe out the excessive oil from the blades.

Storage
Put the trimmer with the accessories back to the original package at a dry and dust free place, out of reach of children and incapacitated people.

TECHNICAL SPECIfICATIONS

• Sharp stainless steel cutting edge
• Adjustable cut lengthwithout extensions 2 – 5 mm
• 4 replaceable extensions (3 – 6 – 9 – 13 mm)
• Very safe handling
• Just corded use
• The package includes a cleaning brush, comb and oil for edge oiling
• Practical shape and design
• Simple operation and easy maintenance
• Easy accessories attachment and replacement
• ON / OFF switch
• Hanging loop
• Power cord length 1,8 m
• Acoustic noise level of 72 db (A)
• Input 8 W
• Size: 6 x 24 x 4 cm
• Weight: 0,3 kg

LEGISLATIVE & ECOLOGY

The product has received ES declaration of conformity according to Act as amended.
The product matches the requirements of the below statutory order as amended.

• Committee Regulation No. 2006/95/ES as amended, setting the technical requirements of the electrical appliance as low.
• Committee Regulation No. 2004/108/ES as amended, setting the technical requirements of products in terms of their electromagnetic compatibility.

The manufacturer reserves the right to make insignificant changes to the standard design that do not affect the function.

WARNING: Do not use this product near water, in wet areas to avoid fire or injury of electric current. Always turn off the product when you don’t use it or before a revision.
There aren’t any parts in this appliance which are reparable by consumer. Always appeal to a qualified authorized service. The product is under a dangerous tention.

Old electrical appliances, used batteries and accumulators disposal

This symbol appearing on the product, on the product accessories or on the product packing means that the product must not be disposed as household waste. When the product/ battery durability is over, please, deliver the product or battery (if it is enclosed) to the respective collection point, where the electrical appliances or batteries will be recycled. The places, where the used electrical appliances are collected, exist in the European Union and in other European countries as well. By proper disposal of the product you can prevent possible negative impact on environment and human health, which might otherwise occur as a consequence of improper manipulation with the product or battery/ accumulator. Recycling of materials contributes to protection of natural resources. Therefore, please, do not throw the old electrical appliances and batteries/ accumulators in the household waste. Information, where it is possible to leave the old electrical appliances for free, is provided at your local authority, at the store where you have bought the product. Information, where you can leave the batteries and accumulators for free, is provided to you at the store, at your local authority.

NOTICE

**** Do not use the appliance close to bath tubs, showers, bash basins or other water containers.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>