TERRA AN2854 RC Centipede User Guide
- June 5, 2024
- terra
Table of Contents
RC CENTIPEDE GIANT SCOLOPENDRA
User Guide
**6+years
AN2854/ AN2354Z / AN2857 / AN2357Z**
FUNCTIONS
**
**
|
**
**
---|---
**
**
|
**
**
Reassembly instructions in case the pegs of the centipede disconnect. If
the centipede disconnects, see Fig. 1 to reconnect.
Step 1: Insert a peg in the centipede’s bottom.
Step 2: Insert a peg in the centipede’s top.
- Switch the On/Off button on the bottom of the centipede to turn the toy on.
- Keep the remote pointed toward the centipede while in use.
- Use centipede only on a flat surface.
- Not suitable for use outdoors or on carpets and sand.
- Keep hair away from motorized wheels to avoid entanglement.
- Excessive dirt and/or water may cause the toy to malfunction.
- The centipede will automatically turn off after 30 minutes when not in use.
|
---|---
( Use On/Off snitch to reactivate the toy from Auto-off mode.| Press the reset
button on the controller to conned centipede
WARNING: CHOKING HAZARD-Small parts. Not for children under 3 years.
WARNING!: SMALL PARTS – CHOKING HAZARD. Not suitable for children under 3
years.
REPLACING BATTERY
Centipede Mille-pattes
|
---|---
Step 1 : Unscrew the battery compartment.
Step 2: Pull out the snake body to replace 3 AAA (1.5V) batteries. See
Fig 2 & Fig 3. (FR):
BATTERY ADVICE
Centipede: 3 x AAA (1.5V). Batteries included. Remote: 2 x AAA (1.5V).
Batteries included. Non-rechargeable batteries are not to be recharged.
Rechargeable batteries are to be removed from the toy before being charged.
Rechargeable batteries are only to be charged under adult supervision.
Different types of batteries or new and used batteries are not to be mixed.
Only batteries of the same or equivalent type as recommended are to be used.
Batteries are to be inserted with the correct polarity. Exhausted batteries
are to be removed from the toy. The supply terminals are not to be short-
circuited.
ATTENTION: When the module’s functions lose performance, follow
instructions carefully to install new batteries. Use alkaline batteries for
longer playtime.
Remote
Waste electrical products and old batteries should not be disposed of with
house’-.old waste. Help protect t U Check with your local authority or
retailer for recycling advice.
Please retain this information for future reference.
**** Please remove all packaging materials before giving them to children.
CAN ICES-3 (B)/NMB-3(B)
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received.
including interference that may cause undesired operation.
Caution: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device. pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates. uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However. there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception. which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
IC:10718A-21E24R07
FCC ID: SLU21E24R07
IC: 10718A-21E24T07
FCC ID : SLU21E24T07
This device contains license-exempt transmitter(s)/receiver(s) that comply
with Innovation. Science and Economic Development Canada’s license-exempt
RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
Frequency bands: 2410MHz-2475MHz Maximum radio-frequency power: 6dbm
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>