SABRENT SB-HTSK Rocket NVMe M.2 SSD Heatsink Installation Guide
- June 5, 2024
- Sabrent
Table of Contents
SABRENT SB-HTSK Rocket NVMe M.2 SSD Heatsink
SABRENT ROCKET HEATSINK
INSTALLATION GUIDE
When installing any NVMe PCle GEN 4 directly onto a PCleGEN 4 motherboard, a
heatsink is required to dissipate the heat generated by the drive’s extreme
speed levels to avoid thermal throttling and to maximize the performance. Many
PCle GEN 4 motherboards are sold with a built in heatsink, so you’re good to
go without an added heatsink. Just follow the manufacturers user manual for
the installation instructions. If your motherboard does not have a built in
heatsink, we recommend using the Sabrent Rocket Heatsink for optimal
performance.
NVMe PCle extreme speeds generate excessive heat, to help dissipate the heat.
Sabrent has developed a state of the art heatsink using the winning
combination of copper and aluminum. The copper is used to absorb the heat from
the drive, spreading It up to the grooved aluminum, giving the heat more air
surface to cool off, therefore avoiding thermal throttling and maximizing the
performance of your drive.
-
Make sure to remove the clear thermal tape protector from the thermal tape, placed both on the heatsink and on the tray, prior to placing the drive in the tray.
-
identify if your SSD is a single-sided or double-sided M.2 drive
SINGLE SIDED
DOUBLE-SIDED -
If your drive is a single-sided drive please continue to step
4 If your drive is double sided please skip to step 5. -
If your drive is a single-sided drive apply the extra thermal tape provided (B) on top of the thermal tape that is already placed on the tray (A) after removing the clear protector from all sides of the thermal tape.
-
Place the SSD in the tray on the thermal tape and make sure the groove meant for the screw placed in the back of the drive is flush with the same groove that is in the back of the aluminum tray.
-
Attach the tray with the drive to the heatsink ensuring that the side h the uneven coils are on the back, on the side of the groove meant for the screw.
-
Align the holes that are on the side of the tray wh the screw holes that are on the side of the heatsink (you may need to apply pressure). Then, insert 2 screws on each side.
-
Insert the drive (with the heatsink) to your motherboard into the M.2 slot. Then insert the screw into the motherboard to hold the drive in place.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>