MARVEL F30760-0SDG-ISH-MT03A RC Spider-Man 2017 Ford GT Instruction Manual

MARVEL F30760-0SDG-ISH-MT03A RC Spider-Man 2017 Ford GT

Charging your Vehicle

1. Make sure the switch is in the ON/CHARGE position.
2. Open the chassis door and pull out the USB charging cable.
3. When plugged into a USB certified port, the green light on the chassis will flash on and off to indicate that the vechicle is charging.
4. Once the vehicle is finished charging, the green light will stop flashing and stay ON.
5. Charging times will vary depending on what kind of port it is plugged into

Remote control

Match Procedure

1. Turn the vehicle ON, then turn the transmitter controller ON within 30 seconds. Push back & forth the trigger once for detection.
   • Do not press any other buttons or switches on the controller while pairing, this may cause interference.
2. The LED on both the vehicle and controller will start blinking.
3. Once the pairing is successful, the LED on both the vehicle and controller will stop blinking and stay on.
4. If pairing is unsuccessful, turn the vehicle and controller OFF and try again.
   • If your controller LED is blinking or losing brightness, please replace the battery.
   •  If your vehicle LED is blinking or losing brightness, please turn off and recharge the vehicle battery.
   •  When playing with multiple vehicles, only pair one controller to one vehicle at a time in order to avoid interference.

Driving

Turbo boost feature

• Press down the Turbo Button to increase the speed of the vehicle
• The light on the controller will flash quickly to indicate that the Turbo Boost is in use
• Release the Turbo Button to resume back to normal speed

Adjustable steering alignment on the vehicle

How to dispose battery

Precautions (Please retain!)

1. WARNING! Not suitable for children under three years. Risk of choking due to small parts that may be swallowed! Please keep this packaging information for any possible correspondence. Subject to technical change and change of color. Adult help is required to remove the securing devices. Hot surface hazard.
2. Never lift the vehicle up while the wheels are still turning.
3. Keep fingers, hair and loose clothing clear from the motor or wheels when the vehicle is switched to “ON”.
4. To prevent accidental operation of the vehicle, batteries and power packs must be removed from the toy when not in use.
5. To avoid accidental operation the vehicle should be switched on before the transmitter. When switching off, always switch off the vehicle and then the transmitter.
6. If the vehicle does not respond after switching On, then switch Off both the vehicle and transmitter and On again. Please also check if full batteries are installed properly into the items.
7. To obtain the best result we recommend using only alkaline batteries or rechargeable battery packs with the vehicle.
8. Check charging unit regularly for damage. In case of damage the charging unit must not be used until it has been fully repaired. The charging procedure must only be undertaken in dry areas; protect unit from damp.
9. We are not responsible for any loss of data, or damage to software, or other damage to computer or accessories caused by battery charging.
10. Wires are not to be inserted into socket-outlets.
11. The toy is only to be connected to Class II equipment bearing the following symbol.
12. This toy contains batteries that are non-replaceable.
13. The power supply is not a toy.
14. Misuse of the power supply can cause electric shock.
15. The toy shall only be used with a power supply for toys.
16. Toys liable to be cleaned with liquids are to be disconnected from the transformer or power supply before cleaning.

Warning:
The manufacturer is not responsible for any radio or television interference which might be caused by unauthorised modifications to this equipment. Modifications of this nature may invalidate the user’s consumer rights.

Declaration of conformity

with directive 2014/53/EU (RED). Dickie-Spielzeug GmbH & Co. KG hereby declares that the item conforms with the standard requirements and the other relevant regulations stipulated in directive 2014/53/EU. The original declaration of compliance can be viewed on the Internet at the following URL: http://www.simba-dickie-group.de/de/konformitaetserklaerungen.shtml

Service

If the product malfunctions, please do not hesitate to contact the sales outlet where you bought the toy. If they are unable to help you, please use our Internet service at Dickie service.dickietoys.de

References

• Home - service.simba-dickie.com
• Konformitätserklärungen - support.dickietoys.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>