SABRENT EC-STUK 3.5-Inch USB 2.0 SATA HDD Enclosure User Manual
- June 5, 2024
- Sabrent
Table of Contents
3.5”USB2.0SATA HARD DRIVE ALUMINUM ENCLOSURE
USER MANUAL
USER’S GUIDE
Congratulations on your purchase of the new Sabrcnt USB 2.0 Hard Drive
Enclosure! The enclosure provides a secure and lightweight method of
transporting and transferring large quantities of data at the fast USB 2.0
speeds, while still being reverse compatible with USB 1.1. Your computer will
quickly detect and configure the connected Hard Drive (Plug & Play) via the
USB connection, with no need to restart the computer. Blazing USB 2.0 speeds
of up to 480Mbps allow you to effortlessly run files directly from your hard
drive, such as, songs, videos, and databases. The aluminum casing effectively
dissipates heat, and its compact sleek design makes for a great travel
companion!
| Transfer interface | USB 2.0 (Reverse compatible with USB 1.1) |
|---|---|
| Transfer rate | Up to 480Mbps (USB 2.0) |
| Supported HDD | 3.5″ |
| Work temperature | -40-65 `C |
| Work humidity | 8%-90% |
| Storage humidity | 5°/0-95% |
| Operating System | Windows 2000/XPNISTA/7; MAC OS X |
System Requirements
- 3.5″ SATA hard drive
- Available USB Port. (Reverse compatible with USB 1.1 ports at reduced speeds)
- Operating Systems: Windows 2000/XPNISTA/7; MAC OS X
- Open the retail package and remove the Hard Drive Enclosure.
- Insert the SATA Hard Drive into the Case.
- Set the jumper settings to MASTER ONLY (If you are unsure of how to do that, contact the Hard Drive manufacturer for detailed instructions)
- Tighten the screws to secure the Hard Drive to the base.
- Slide the base into the outer enclosure, and secure it with the screws.
- Connect the AC power adapter to the wall and the Enclosure.
- Turn on the switch to ON.
- Connect the USB cable to an available USB port on the computer
At this point the Hard Drive is completely installed. No Software or Drivers
are needed to complete the connection. The Hard Drive Enclosure should appear
in Device Manager under the “Universal Serial Bus Controllers” as “USB Mass
Storage” (There should be no error icon: “?’ or t) and the Hard Drive should
appear in “MY COMPUTER” as a new Drive Letter.
If the Hard-Drive is brand new you may need to first format it to make the
Drive Letter appear. Right-click on MY COMPUTER, Select MANAGE, Go to DISK
MANAGEMENT, go to the drive information in the Right column and Right-click on
the drive to Initialize, Partition, Assign Drive Letter and Format. We
recommend the NTFS file system. At this point you should get the Drive letter
in MY COMPUTER.
For installation issues,
please contact [email protected]