Bluestone MCW4 Infrared Auto Clamp Wireless Charging Car Mount User Manual
- June 5, 2024
- Bluestone
Table of Contents
Bluestone MCW4 Infrared Auto Clamp Wireless Charging Car Mount
INTRODUCTION
This mount is one of the only of its kind that is on the market. It uses Infrared technology to secure your phone. A simple touch can release the phone. How simple! If only it could drive the car itself too now! But with this mount, it’ll make navigating and driving so much more easier you might even start to enjoy driving again! With a selection of colors, chose one that fits your car and personality the best! No need to settle and have a boring black car mount anymore.
PACKAGE CONTENTS
1 x Wireless Charging Mount
1 x Air Vent Clip
1 x Charging Cable
PRODUCT OVERVIEW
SPECIFICATIONS & FEATURES
Mount is approx 12cm h x 7cm w x 5cm d
Infrared Sensor to detect phone
Auto Lock and Release
Feet to support phone from falling
Touch sensor for clamp release
360° rotating phone bracket
Easy Installation
Overheating Protection
Fast Charging
Vent Clip can easily fit into any vent system
Compatible with wireless charging devices
Power: 10 W Fast Charging
Input: 5V2A, 9V2A
Output: SV/1A, 9V/1.1A
HOW TO USE
Constructing the Mount
- Un box all pieces and make sure you have everything
- Take the mount line it up with the clip
- Screw joint part onto the back of the body but loosely
- Leaving it loose will allow for the ball to pop in easily
- Once the ball is in socket, tighten knob and make sure its tight
- Place mount on dashboard or in vent in desire location
- Next plug in the USB part of the wire to your power source
- Plug the Micro B port into the mount head to power it up
- Once the mount is powered – the infrared will activate
- Place Phone in front of mount and the wings should open for you to place phone in
- Phone should immediately begin to charge – If not – make sure your case isn’t too bulky that is it blocking the charging power of the mount
- When done using the mount, please your hand gently on the back top of it and it will release phone.
CARE AND SAFETY
- Do not use this unit for anything other than its intended use.
- Keep the unit away from heat source, direct sunlight, humidity, water or any other liquid.
- Do not operate the unit if it has been wet or moist to prevent against electric shock and/or injury to yourself and damage to the unit.
- Do not use the unit if it has been dropped or damaged in any way.
- Repairs to electrical equipment should only be performed by a qualified electrician. Improper repairs may place the user at serious risk.
- Keep the unit out of reach of children.
- This unit is not a toy.
©SM TEK GROUP INC, All rights reserved.
Bluestone is a trademark of SM TEK GROUP INC.
New York, NY 10001
www.smtekgroup.com