Bluestone MCW2 Wireless Car Charger User Manual
- June 5, 2024
- Bluestone
Table of Contents
Bluestone MCW2 Wireless Car Charger
INTRODUCTION
Need a charge while on your way somewhere? Need to navigate but also charge? No problem! Do both! There’s no reason to do one or the other anymore. The future is here and its well charged. Mount this to your dash or to your vent with the clip. Either way, it will mount easily while also charging. Just make sure it’s plugged in and your phone is flat against the back of the mount. And you’ll be on your way, fully charged, in no time!
PACKAGE CONTENTS
- 1x Wireless Charging Phone Mount
- 1x Dash/Windshield Suction Attachment
- 1x Vent Clip Mount
- 1x Mount Cable
PRODUCT OVERVIEW
SPECIFICATIONS & FEATURES
The stand is approx 11 cm tall by itself The Mount’s head is approx 6.5cm in diameter The suction cup is 6.5 in diameter Strong and secure suction cup to stick to any flat surface The adjustable wings cant hold a phone up to 3.5 inches wide Short mount stand in order to not block view sight 360 rotating phone bracket
- Easy Installation
- Sticky suction cup
- Can adhere to any flat surface
- Also comes with a bonus vent clip
- Compatible with wireless charging devices
- Power: 10W Fast Charging
- Input: 5V2A, 9V2A
- Output: 5V/1IA, 9V/1.1A
HOW TO USE
Constructing the Mount
- Unbox all pieces and make sure you have everything
- Take the mount head and line it up with the stand
- Screw joint part onto the back of the square but loosely
- Leaving it loose will allow for the ball to pop in easily
- Once the ball is in the socket, tighten the knob and make sure it’s tight
- Take the plastic peel off of the suction cup
- Place the mount on the dashboard or in the vent in the desired location
- Next plug in the USB port of the wire to your power source
- Plug the Micro B port into the mount head to power it up
- Pull down the lever on the bottom of the stand to make sure that the suction is extra secure
- Extend wings on mount head and place phone in between them and allow it to clamp it securely tight
- The phone should immediately begin to charge – If not – make sure your case isn’t too bulky that is it blocking the charging power of the mount
CARE AND SAFETY
- Do not use this unit for anything other than its intended use.
- Keep the unit away from heat sources, direct sunlight, humidity, water, or any other liquid.
- Do not operate the unit if it has been wet or moist to prevent electric shock and/or injury to yourself and damage to the unit.
- Do not use the unit if it has been dropped or damaged in any way.
- Repairs to electrical equipment should only be performed by a qualified electrician. Improper repairs may place the user at serious risk.
- Keep the unit out of reach of children.
- This unit is not a toy.
Address
@SM TEK GROUP INC, All rights reserved. BlueStone is a trademark of SM TEK GROUP INC. New York, NY 10001 www.smtekgroup.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>