VISUAL COMFORT TOB 5453 Piaf Grande Two-Tier Chandelier Instruction Manual
- June 5, 2024
- VISUAL COMFORT
Table of Contents
VISUAL COMFORT TOB 5453 Piaf Grande Two-Tier Chandelier
ASSEMBLY INSTRUCTIONS
Piaf Grande Two-Tier Chandelier
Item # TOB 5453
NOTICE:
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect item and contents
carefully. If any damage or defect is found, do not install. Retain all
packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
- Phillips Screwdriver
- Wire Strippers
- Slotted Screwdriver
- Wire Cutters
Instructions
-
Carefully remove all parts from the box. Place on a clean, soft surface.
-
Remove mounting plate (B) from canopy (F) by removing collar ring (G).
-
Install mounting plate (B) to junction box and secure with mounting screws (C).
-
Feed electrical wires through bottom rod (J) and connect to fixture body (K). Repeat for middle rod (I), connecting to bottom rod (J).
-
Feed electrical wires through top rod (H) and remove swivel ball (Q) from top rod (H).
-
Let collar ring (G) and canopy (F) pass though top rod (H), then secure swivel ball (Q) to top rod (H) and connect top rod (H) to middle rod (I).
-
Hang fixture swivel ball (Q) to the center of mounting plate (B) and secure with set screw (D) with provided wrench (E).
NOTE: Slide components down slowly to avoid damages. -
Cut excess wires, being sure to leave enough to reach the junction box. Separate wires, and strip insulation on each 5/8″.
-
Wrap fixture ground wire (bare copper) around the green grounding screw (see diagram 1). Tighten. Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut (A).
NOTE: It is imperative that the fixture is grounded.
Piaf Grande Two-Tier Chandelier
Item # TOB 5453
NOTICE:
This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved. -
Connect fixture neutral wire (white) to the supply neutral wire (usually white) using wire nut (A).
-
Connect fixture hot wire (black) to the supply hot wire (usually black) using wire nut (A).
CAUTION: Do not reverse the hot and neutral connections. -
Make sure all wire connections are tight, then carefully tuck into the junction box.
-
Install canopy (F) to mounting plate (B) and secure with collar ring (G).
-
Install light bulbs into the sockets.
-
Clip shades (L) onto the bulbs.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do
Not use abrasive or chemical agents. 
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>