VISUAL COMFORT CHC 5446 Alessa X-Large Chandelier Instruction Manual
- June 4, 2024
- VISUAL COMFORT
Table of Contents
CHC 5446 Alessa X-Large Chandelier
Instruction Manual
ASSEMBLY INSTRUCTIONS
NOTICE:
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect items and contents
carefully. If any damage or defect is found, do not install. Retain all
packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
| Phillips Screwdriver | Slotted Screwdriver | Chain Pliers |
|---|---|---|
| Slip Joint Pliers | Measuring Tape | Wire Cutters |
| Wire Strippers |
-
Carefully remove all parts from the box. Place on a clean, soft surface.
-
Remove collar loop (D) from the chain (H) by removing quick link (E).
-
Install mounting plate (B) to the junction box and secure with mounting screws (C).
-
Secure collar loop (D) to mounting plate (B) using pliers to tighten locknut.
-
Install canopy (F) to collar loop (D) and secure with collar ring (G).
-
Determine desired overall length, and amount of chain (H) needed. Shorten chain using chain pliers. (Keep extra chain)
-
Attach chain (H) to collar loop (D) and fixture loop (I) using quick links (E). Secure quick links (E).
-
Thread fixture wire and ground wire through the chain (H). NOTE: When you reach the collar loop (D), ensure there is no tension on the wires. Cut excess wires, being sure to leave about 12” to reach the junction box.
-
Separate two sides of the molded wire, and strip insulation on each 5/8″.
-
Loosen collar ring (G) and let canopy (F) slip down the chain (H) carefully.
-
Twist all fixture wires together and slip through the center hole of the collar loop (D). NOTE: Untwist wires and separate to prepare for connection.
NOTICE: This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect items and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved. -
Wrap fixture ground wire (bare copper) around the green grounding screw (see diagram 1). Tighten. Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut (A).
NOTE: It is imperative that the fixture is grounded. -
Connect fixture neutral wire (ribbed) to the supply neutral wire (usually white) using wire nut (A).
-
Connect fixture hot wire (smooth with markings) to the supply hot wire (usually black) using wire nut (A).
CAUTION: Do not reverse the hot and neutral connections. -
Make sure all wire connections are tight, then carefully tuck into the junction box.
-
Install canopy (F) to collar loop (D) and secure with collar ring (G).
-
Install light bulbs into the sockets.
Crystal Assembly – Use diagrams 2 & 3 to complete below:
- Hang crystal stands (L) to the bottom of the ring (P), then hang opposite end to the top of the middle ring (Q).
- Hang crystal stands (O) to the bottom of the ring (Q), then hang opposite end to holes on a metal plate (R).
- Hang crystal drops (J & K) to the top of the ring (P).
- Hang crystal drops (N) to the bottom of the ring (Q).
Care Instructions: Clean only with a soft dry cloth or feather duster. Do Not use abrasive or chemical agents.