MXA300.4
300 WATT 4-CH AMPLIFIER

MEMPHIS XTREME AUDIO

Memphis Xtreme Audio amplifiers were designed to withstand water and the elements. These amplifiers are IP66 certified for water resistance making them a perfect solution for Powersports and marine situations. The compact chassis allows these amps to fit virtually anywhere allowing them to be used in a variety of ways.

FEATURES

• Sealed chassis for water protection in extreme environments
• Ultra-efficient full range class D operation
• High and low-level inputs – connects with any system
• Built in crossover for maximum flexibility
• 2 or 4 – Channel Input
• Durable stainless steel & aluminum hardware

SPECIFICATIONS

• IP66 Water resistant
• High/Low-Level inputs
• Sealed Connectors
• Compact footprint

CONTROLS / FUNCTIONS

|
---|---

1. INPUT MODE SWITCHES
   Set the configuration to 2 channel or 4 channel Allowing easy connection for front and rear RCA output head units. Prevents using Y-adapter for head units with only one
   RCA output

2. HIGH PASS / LOW PASS FILTER REAR CROSSOVER VARIABLE GAIN ADJUSTMENT

3. HIGH PASS / LOW PASS FILTER FRONT CROSSOVER VARIABLE GAIN ADJUSTMENT

4. LOW (RCA) HIGH-LEVEL INPUT

5. POWER INPUT CABLE
   Yellow: +12V Black: Ground Blue: Remote In +12V and ground each have two wires. Please connect both pairs of wire to +12V and Ground

6. SPEAKER OUTPUT CABLE
   White: Front Output Left ( + )
   White/Black: Front Output Left ( – )
   Gray: Front Output Right ( + )
   Gray/ Black: Front Output Right ( – )
   Green: Rear Output Left ( + )
   Green/Black: Rear Output Left ( – )
   Violet: Rear Output Right ( + )
   Violet/Black: Rear Output Right ( – )

INSTALLATION INFORMATION

Memphis Audio recommends the installation of our products be performed by an Authorized dealer. Attempting an installation project on your own or through an unauthorized source may result in damage to your products and may potentially void your warranty.
MXA amplifiers can be mounted in numerous locations, we typically recommend mounting them away from the elements. We recommend mounting them in an area that avoids direct contact with water. A proper mounting location will also allow for adequate ventilation allowing heat to dissipate.

WARNING
For your safety, always inspect the mounting location carefully to ensure you are not drilling into any electrical, hydraulic, fuel, or fluid lines. Always check your speaker load with a multi-meter before connecting the amplifier. Connecting any speaker load lower than the rated impedance of the amplifier will result in damage to the amplifier. Damage of this nature is NOT covered under warranty. Please pay close attention to what connections are made to the amplifier.
If you are uncertain or uncomfortable proceeding with your installation, please contact your local Authorized Memphis Audio Dealer

TROUBLESHOOTING

When troubleshooting your amp, speaker and speaker wires should be tested first
NO OUTPUT

• Confirm all wiring is firmly connected.
  Both +12V and REM terminals must have +12 Volts present and GND must be connected to the chassis ground or to the negative battery terminal.

• Confirm the signal source is connected and supplying an output signal. To confirm the amp is working, connect an RCA patch cord to the line inputs of the amplifier (do not connect the other end of the patch cord). Briefly tap the center pin of each disconnected RCA with your finger. This should produce a noise (brief static or hum) in the speakers.

• If the amp is hot, check the speaker impedance or load. The total minimum impedance of all speakers should not be lower than the rating of the amp

WEAK OUTPUT

• Check gain control adjustment
• Check speaker impedance.

UNWANTED NOISE

• Whine that increases and decreases with engine speed – confirm the Amp & Source unit are grounded properly.
• Clicking or popping noise at a rate that follows engine speed – is often induced by the vehicle’s ignition system. Confirm that the vehicle is equipped with resistor spark plugs and wires. The ignition system may need service.
• Noise can be caused by routing speaker input wires too close to the light wires and other accessory wires in the vehicle. Re-route wires to avoid unwanted interference.
• If the above steps do not improve/reduce noise, the system should be checked by a professional audio installer at a Memphis Authorized Dealer.

LOW-LEVEL INPUT WIRING

HIGH-LEVEL INPUT WIRING

POWER INPUT WIRING

SPEAKER OUTPUT WIRING

4- CHANNEL OUTPUT

BRIDGED 2-CHANNEL OUTPUT

WARRANTY

This product has a two-year warranty from the date of purchase for defects in material or workmanship. This warranty will be extended to 3 years when installed by a Memphis authorized dealer using Memphis Connection products. The warranty is void if the product has been physically damaged by improper usage or abuse. If repairs are attempted outside of a Memphis Audio facility, the warranty is void.
This warranty is limited to the original retail purchaser and does not cover any expenses incurred in the removal or re-installation of the product. This warranty does NOT apply to product exterior and cosmetics. Memphis Audio disclaims any liability for incidental or consequential damages caused by product defects. Memphis Audio’s liability will not exceed the purchase price of the product and the warranty period specified.
What is NOT covered under the warranty

• Damage due to improper installation
• Damage caused by exposure to moisture, excessive heat, chemical cleaners, and/or UV radiation
• Damage through negligence, misuse, accident, or abuse. (Repeated returns for the same damage may be abuse)
• Product damaged in an accident and/or due to criminal activity
• Service performed by anyone other than Memphis Audio
• Subsequent damage to other components
• Any cost or expense related to the removal or re-installation of product
• Products with tampered, missing, altered, or defaced serial numbers/labels
• Freight damage
• The cost of shipping products to Memphis Audio
• Return shipping on non-defective items
• Any product not purchased from an authorized Memphis Audio dealer

Some states do not allow the exclusion or limitation of incidental or consequential damages. The above limitations or exclusions may not apply to you. This warranty gives you specific rights, you may have other rights which vary from state to state.
If warranty service is required, a return authorization number is required to return the product to Memphis Audio. Warranty shipments to Memphis Audio are the responsibility of the purchaser. Pack the product carefully in the original carton if possible Memphis Audio will not be responsible for damages incurred in shipment or due to improper packaging materials used by the purchaser.
If determined to be within warranty your product will be repaired or replaced at the discretion of Memphis Audio.

ENGINEERED TO RESIST WATER & ELEMENTS CONTACT US
122 GAYOSO AVE, MEMPHIS, TN. 38101
TECH SUPPORT: 800.489.2300
WWW.MEMPHISCARAUDIO.COM
@MEMPHISCARAUDIOUSA
@MEMPHISCARAUDIO

MEMPHISAUDIO

ESTABLISHED NINETEEN SIXTY-FIVE
MEMPHIS TENNESSEE
UNITED STATES OF AMERICA

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>