Qlima DD808 Cold Room Dehumidifier User Manual

: June 4, 2024
: Qlima

Table of Contents

SAFETY INSTRUCTIONS
GENERAL
OPERATING INSTRUCTIONS
WATER TANK FULL ALERT
MEMORY FUNCTION
SYNC MOTOR FAILURE
PROTECTION AGAINST FALLING OVER
CONTINUOUS DRAINAGE FUNCTION
CLEANING THE FILTER
MAINTENANCE
CONDITIONS OF WARRANTY
TECHNICAL SPECIFICATIONS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Qlima DD808 Cold Room Dehumidifier User Manual

SAFETY INSTRUCTIONS

Read this user manual carefully before using the appliance and keep it for future reference. Install this device only when it complies with local/ national legislation, ordinances and standards.
This product is intended to be used as a dehumidifier in residential houses and is only suitable for use in normal household conditions, indoors in living room, kitchen and garage. This unit is only suitable for earthed sockets, connection voltage 220-240 V. / ~50 Hz.

GENERAL

Ensure that all windows are closed in order to achieve maximum efficiency.
The capacity of the dehumidifier depends on the temperature and the humidity in the room.
Ensure that the screen filter is kept clean. This prevents unnecessary power consumption and guarantees optimum efficiency.
If the power supply has been interrupted, the dehumidifier will restart after three minutes.
If the unit ever tips or falls over, unplug the power cord immediately. Make sure the unit has dried out thoroughly before operation if the unit ever tips or falls over when water tank is filled.
Do not use the unit in bathroom or shower room.
Do not use the unit near flammable materials or fire.
Do not unplug unit from power socket with wet hands.
Switch off the power before removing the plug from power socket.
Empty the water when water tank full or not in use for a prolonged period.
To disconnect the power, grip the plug and pull 4 it out from power socket, never drag the cord.

IMPORTANT
The device MUST always have an earthed connection. If the power supply is not earthed, you may not connect the unit. The plug must always be easily accessible when the unit is connected. Read these instructions carefully and follow the instructions.

Before connecting the unit, check the following:

The voltage supply must correspond with the mains voltage stated on the rating label.
The socket and power supply must be suitable for the current stated on the rating label.
The plug on the cable of the device must fit into the wall socket.
The device must be placed on a flat and stable surface.

The electricity supply to the device must be checked by a recognised professional if you have any doubts regarding the compatibility.

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
This device is manufactured according to CE safety standards. Nevertheless, you must take care, as with any other electrical device.
Do not cover the air inlet and/or outlet.
Empty the water reservoir before moving the unit.
Never allow the device to come into contact with chemicals.
Never submerge the unit in water.
Do not insert objects into the openings of the unit.
Always remove the plug from the electric power supply before cleaning or replacing the unit or components of the unit.
Never use an extension cable to connect the device to the electric power supply. If there is no suitable, earthed wall socket available, have one installed by a recognised electrician.
Children should be supervised to ensure that they do not play with the appliance.
Have any repairs only carried out by a recognised service engineer or your supplier. Follow the instructions for use and maintenance as indicated in the user manual of this device.
Always remove the plug of the unit from the wall socket when it is not in use.
If the power cable is damaged it must be replaced by the manufacturer, its customer ser- vice department or persons with comparable qualifications in order to prevent danger.
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
Cleaning and user maintenance shall not be made by children without supervision.

ATTENTION!

Never use the device with a damaged power cord, plug, cabinet or control panel.
Never trap the power cord or allow it to come into contact with sharp edges.

ATTENTION!

Failing to follow the instructions may lead to nullification of the guarantee on this device.

THE CONTROL PANEL

Working temperature range: 5°C-35°C

OPERATING INSTRUCTIONS

FUNCTIONS OF CONTROL PANEL

The POWER button can be used to turn the power on or off
Plug the unit into the power socket, the buzzer will beep 3 times. All LEDS on the display will be lighted for 1 sec. The louver will be raised to 80 degrees.
Use the POWER button to turn on the unit. the unit will start in continuous humidification mode by default. The fan will operate at speed 2
Pressing the POWER button will also switch the unit off again. The fan motor will continue to run for about 10 minutes to allow the temperature of the desiccant and heating element to drop after the power is turned off. The plug should not be unplugged until no more air flows from the outlet.
The TIMER button can be pressed to set a timer when the unit will switch off.
When the timer is set, the timer indicator lights up. When the timeris set, the display shows the currently set timer data for 3 seconds and then switches to the display of the current humidity level.
When the timer button is pressed for 3 seconds, the child lock can be switched on or off (If the power is suddenly switched off and then on again, the appliance will not remember the child lock).
Press the HUMIDIFICATION button to set the humidity: CO→40%→45%→50%→55%→60%→65%→70%→75%→80%, CO stands for continuous humidification.
Press the MODE button to set the mode to 1(Low)-2(Medium)-3(High)-Auto.
If the unit operates in fan mode only, press the button to set the fan level to 1(Low)-2 (Medium)-3 (High).
When the machine works continuously for 360 hr, the display will show the P3 code to remind the user to clean the filter. Then press the button for 3 sec to clean the P3 code, then the P3 code will disappear and the display will show the current ambient temperature level.
Press the SWING button to turn the swing function on/off
Press the FAN button to turn the fan function on/off.
When the unit is in fan function, the user can press the SPEED button to set the fan speed to 1(low)-2(medium)-3(high).
Beep on/off button:
When the unit is operating, press the SWING and TIMER button for 3 sec to turn the beep on or off.
Humidity level indicator:
The LED-indicator is in the front casing of the unit.
When the humidity≤59%, the indicator lights green;
When the humidity is ≥60%, the lights illuminate orange;
When the humidity is ≥70%, the lights illuminate red.

WATER TANK FULL ALERT

When the unit‘s water tank is full, a signal will be emitted for 10 times and the water-full indicator light will come on. The unit will then stop working immediately. Make sure the water tank is emptied and placed back into the unit correctly. The unit will then resume operating in its last set mode.

MEMORY FUNCTION

When the appliance is switched off and it is then in standby mode, it will remember the last setting and it will start up when the appliance is switched on again.
If the power fails while the appliance is switched on, the appliance will also remember the last setting for when the power is switched on again.
When the child lock and timer are set, the appliance switches off when the time has elapsed. At that time, the appliance will not remember the child lock for when it is set again, it will have to be reactivated.

SYNC MOTOR FAILURE

When Sync motor failure, the unit will show C4. The Main motor, Sync motor and hot air motor will stop working after 10 mins.

Error code	Reason
C1	NTC1 is open cut or short cut
C2	NTC 2 is open cut or short cut
C3	NTC1 &NTC 2 are open cut or short cut
C4	Sync motor is failure
P3	Pre-filter clean notice
88	Temperature and humidity sensor is failure

PROTECTION AGAINST FALLING OVER

The machine has a heater inside. To prevent overheating, the machine is equipped with a tilt switch that automatically switches off if the machine falls over.

CONTINUOUS DRAINAGE FUNCTION

The dehumidifier has a continuous drain hole that can be connected to a plastic pipe of 2m long. The water can be drained into a sink or larger container. This unit uses gravity to drain the collected water and therefore the drain should be lower than the dehumidifier‘s water outlet. Make sure that the drain pip runs down and allows the water to flow out smoothly. Do not kink or bend the pipe.“

CLEANING THE FILTER

The air intake can easily collect dust, so clean it regularly with a soft, damp cloth. If the filter is covered with dust, the airflow and performance of the unit will be affected. It may even cause damage to the unit. We recommend cleaning the filters regularly. The dehumidifier must be unplugged before maintenance and the filters must be completely dried before use.

Remove the filters from the unit and pat away the dust.
Clean the mesh filter with a hoover or soft brush.
If dirt and grease have accumulated, wash the mesh filter in hot soapy water.
This should dry thoroughly before replacing the filter in the appliance.“

MAINTENANCE

Maintenance

Do not place the appliance in direct sunlight as the housing is made of plastic.
Remove the water tank carefully. Do not use alcohol, petrol or other benzene containing chemical solvents to clean the appliance.
Keep the filter clean: remove the filter, then use a hoover or water to clean it, then put it in a ventilated place until it is dry.
Unplug the appliance before cleaning or performing other maintenance work.
Turn off the appliance, unplug the power cord and remove the water from the tank before putting the appliance away.
If you are not going to use the appliance for a long time, switch it off, unplug it, empty the water tank and wait 2 days to ensure the appliance is completely dry inside before packing it away. Then make sure the appliance is stored upright. Do not place the appliance horizontally or upside down.
If the appliance needs repair. Enlist the help of after-sales service or another professional person. We are not responsible for accidents or damage caused by repairing the appliance yourself.
Send the waste after repairing the machine to the factory qualified for waste disposal.
When the life of the machine has expired, take it to the professional manufacturer for environmental protection. Do not throw it away.

CONDITIONS OF WARRANTY

There is a two-year warranty on your dehumidifier from the date of purchase. All material or manufacturing defects will be repaired free of charge.

The following applies:

All claims for compensation, including consequential damage, will not be entertained.
Any repairs or replacement of components during the warranty period will not result in an extension of the warranty period.
The warranty will expire if any alterations have been made, not genuine components have been fitted or if the dehumidifier has been repaired by a third party.
Components subject to normal wear and tear, such as the air filter, are not covered by the warranty.
The warranty is only valid on presentation of the original, unaltered, and datestamped purchase receipt.
The warranty does not cover damage caused by actions that deviate from those as described in the user’s manual or by neglect.
Transportation costs and the risks involved during the transportation of the dehumidifier or components shall always be for the account of the purchaser.

To prevent unnecessary expenses, we recommend that you always carefully read the user’s manual first. If this does not provide a solution, take the dehumidifier to your distributor for repair.

Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities. Contact your local government for information regarding the collection systems available. If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into the groundwater and get into the food chain, damaging your health and well-being. When replacing old appliances with new once, the retailer is legally obligated to take back your old appliance for disposal at least for free of charge. Do not throw batteries into the fire, where they can explode or release dangerous liquids. If you replace or destroy the remote control, remove the batteries and throw them away in accordance with the applicable regulations because they are harmful to the environment.

TECHNICAL SPECIFICATIONS

Model	DD808
Rated Voltage	230V/50HZ
Humidification	8.0L/D (20°C 60%RH)
Power consumption	610W (20°C 60%RH)
Air volume	150m3/h
Outlet air temperature	≥40°C
Water tank size	2.0L
Dimension	358213537mm