Schlage Keypad Lock [FE575] User Manual

: June 2, 2024
: Schlage

Installation Instructions

SCHLAGE

$Schlage Keypad Lock \[FE575\] Image$

Schlage Keypad Lock [FE575]

Keypad Lock

Fig 2 Keypad Lock

Prepare for Installation

Tools Needed

Phillips screwdriver
Tape Measure
Pencil

Optional

Flathead Screwdriver
Wood Block
Hammer

Additional Parts

Fig 1 Additional Parts

IMPORTANT NOTES

DO NOT use a power drill for installation!
Use a screwdriver to remove product from packaging.
Install and test lock with door open to avoid being locked out.

A. Check door dimensions.

Fig 3 Check door dimensions.

B. Change faceplate, if necessary.

Choose the drawing that matches your door edge. If the hole has no mortise, change to the circular faceplate.

Fig 4 Change faceplate

Fig 5 Change faceplate

Install Lock

1. Install latch.

Make sure latch angle faces door jamb.

Fig 6 Install latch

2. Install strike onto door jamb.

Fig 7 Install strike onto door jamb.

3. Install battery.

Fig 8 Install battery.

4. Install keypad.

Fig 9 Install keypad.

Bar should slide smoothly through hole in latch. If not, check door dimensions.

5. Install lever.

Fig 10 Install lever.

6. If needed, switch levers.

Fig 11 switch levers.

Fig 12 switch levers.

Fig 13 switch levers.

Fig 14 switch levers.

Test Lock

A. Unlock.

Fig 15 Unlock.

Program Lock

See the Keypad Locks Programming Guide that came with this lock. See the Keypad Locks User Guide for additional information.
Go to keypad.schlage.com for videos and more.
Register your product at RegisterMySchlage.com.

Lifetime Limited Mechanical and Finish Warranty and 3-Year Limited Electronics Warranty
Subject to the terms and conditions of this warranty, Schlage extends a lifetime limited mechanical and finish warranty and a three-year limited electronics warranty to the original consumer user (“Original User”) of our Schlage brand product (“Product”) against defects in material and workmanship, as long as the Original User occupies the residential premises upon which the Product was originally installed.

What Schlage will do: Upon return of the defective Product to Schlage, Schlage’s sole obligation, at its option, is to either repair or replace the Product, or refund the original purchase price in exchange for the Product.

Original User: This warranty only applies to the Original User of Products. This warranty is not transferable. What is not covered: The following costs, expenses and damages are not covered by the provisions of this limited Warranty: (i) labor costs including, but not limited to, such costs as the removal and reinstallation of Product; (ii) shipping and freight expenses required to return Product to Schlage; and (iii) any other incidental, consequential, indirect, special and/or punitive damages, whether based on contract, warranty, tort (including, but not limited to, strict liability or negligence), patent infringement, or otherwise, even if advised of the possibility of such damages. Some local laws do not allow the exclusion or limitation of incidental or consequential damages, so the above exclusion or limitation may not apply to you.

The provisions of this warranty do not apply to Products: (i) used in commercial applications; (ii) used in common area applications; (iii) used for purposes for which they are not designed or intended; (iv) which have been subjected to alteration, abuse, misuse, negligence or accident; (v) which have been improperly stored, installed, maintained or operated; (vi) which have been used in violation of written instructions provided by Schlage; (vii) which have been subjected to improper temperature, humidity or other environmental conditions; or (viii) which, based on Schlage’s examination, do not disclose to Schlage’s satisfaction non-conformance to the warranty. Additionally, this warranty DOES NOT COVER scratches, abrasions, or deterioration due to the use of paints, solvents or other chemicals.

Exclusions: Oil Rubbed Bronze finish (613) is designed to improve over time and change in appearance, creating a living finish through daily use and thus, finish discoloration is not applicable to the above warranty. Additional terms: Schlage does not authorize any person to
create for it any obligation or liability in connection with the Product. Schlage’s maximum liability hereunder is limited to the original purchase price of the Product. No action arising out of any claimed breach of this warranty by Schlage may be brought by the Original User more than one (1) year after the cause of action has arisen.

How local law applies: This warranty gives you specific legal rights, and you may also have other rights as otherwise permitted by law. If this Product is considered a consumer product, please be advised that some local laws do not allow limitations on incidental or consequential damages or how long an implied warranty lasts, so that the above limitations may not fully apply. Refer to your local laws for your specific rights under this warranty.

Guaranteed Fit Program: Schlage products are designed to fit standard residential door preparations and retrofit existing tubular locks.
Note: Mortise locks and preparations are not considered standard and are not guaranteed under this program. During the initial installation, if there is a problem with the Product’s performance, the Original User may simply contact Schlage Customer Service at 888-805- 9837 in the U.S. and Canada or 800-506-7866 in Mexico for assistance. Program and warranty claims: If you encounter a residential door preparation or fit issue under the Guaranteed Fit Program or have a claim under this warranty, please contact Schlage Customer Service for repair, replacement or refund of the original purchase price in exchange for the return of the Product to Schlage.

Schlage Customer Service
Calling From:
U.S.A.: 888-805-9837
Canada: 800-997-4734
Mexico: 018005067866