Danfoss AN325057 Icon Wireless Room Thermostat Installation Guide

: June 1, 2024
: Danfoss

Table of Contents

Installation
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Danfoss Icon™ Wireless
Room Thermostat

Installation

Follow the instructions in Figures 1-6.
Activating the thermostat
Touch the screen – displays the actual room temperature (Figure A).
When heating is on, the heating icon is displayed, and when cooling is on, the cooling icon is displayed . The screen turns off after 10 seconds.
Setting the temperature
Activating the thermostat. To set the temperature (temperature flashing indicates that the setting is in progress) press or . Press to confirm the new setting .
Opening the settings menu
Activating the thermostat. Press and hold to open the menu (Figure B).
Press or to move in the menu, press to confirm . Press to move back in the menu .
Installer menu
Press and hold to access the settings menu. Press and hold in the settings menu to access the installer menu .
Menus
Limitation of the setting range of the room temperature setpoint.
Information/version number, can be used to identify the product.
Conducting a control regulator connection test. Shows a score of 0-100% (80% or higher is a very strong connection).
Floor sensor mode:
= comfort mode. Air and floor sensors are used.
= floor sensor mode. The end user can set the desired floor temperature.
= dual control mode. The thermostat controls the radiator and floor heating circuits. Underfloor heating circuits ensure a minimum floor temperature and the radiator is used for peak loads.
Min and max floor temperature, used in mode and .
Reference room. Switch to ON if you want to use this thermostat as a reference thermostat to switch between cooling and heating.
Cooling ON/OFF. Use to turn off cooling, e.g. in the bathroom.
Note! Menus 4, 6 and 7 are only available to the installer.
Menus 4 and 5 only for infrared model 088U1082.
Changing the batteries (Figure C)
When the batteries are almost empty, the thermostat will display the message “BAT LO” after activation.
To change the batteries, push the thermostat up and release it from the wall plate and replace the old batteries with two high-quality AA 1.5V batteries. EC DECLARATION OF CONFORMITY
Danfoss A/S hereby declares that this radio device type is Wireless Room Thermostat meets the requirements of Directive 2014/53/EU.
The full text of the EU Declaration of Conformity is available at the following internet address: heating.danfoss.com
Danfoss is not responsible for possible errors in catalogs, advertising brochures or other forms. Danfoss reserves the right to make changes to products, including those already ordered, without prior notice in the products, so that it does not change the previously agreed »parameters«.
All trademarks in this trick are the property of their respective companies. Danfoss and all Danfoss logos are trademarks of Danfoss A/S. All rights reserved.

Danfoss AS
Heating Segment « danfoss.ee + +372 659 3300 « E-mail: klienditeindus.ee@danfoss.com
AN325057825153et-EE0101 | 088N2110 00 EE www.icon.danfoss.com