iBoard IB-P097 Black Running Boards Style Installation Guide
- June 1, 2024
- iBoard
Table of Contents
iBoard IB-P097 Black Running Boards Style
READ INSTRUCTIONS CAREFULLY BEFORE START ING INSTALLATION. REMOVE CONTENTS FROM BOX AND VERIFY ALL PARTS ARE PRESENT. ASSISTANCE IS RECOMMENDED.
ROCKER PANEL MOUNT
NO DRILLING REQUIRED
PART LIST
| Fastener Size | Tightening Torque (ft-lbs) | Required |
|---|---|---|
| 6mm | 6-7 | X |
| 8mm | 16-18 | √ |
| 10mm | 31-32 | X |
| 12mm | 56-58 | X |
| 14mm | 92-94 | X |
Hardware Package A (For Bracket Installation)
Hardware Package A (For Bracket Installation)
Item| QTY| Description| Item| QTY| Description
1#| 1| Driver Front Mounting Bracket| 4#| 16| M8Χ1.25-30mm Hex Bolts
2#| 1| Passenger Front Mounting Bracket| 5#| 16| M8 Flat Washers
3#| 6| Mounting Brackets| 6#| 16| M8 Lock Washers
Hardware Package B (For Step Bar Installation)
Hardware Package B (For Step Bar Installation)
Item| QTY| Description| Item| QTY| Description
1#| 16| M8X1.25-35mm Carriage Bolts| 3#| 16| M8 Nylon Lock Nuts
2#| 16| M8 Large Flat Washers| 4#| 8| Sliders (Packed with Mounting Brackets)
Installation
STEP 1
Start installation from the driver side of the vehicle. Select the Driver
Front Mounting Bracket. Attach the Bracket to the vehi-cle using the included
(2) M8x1.25-30mm Hex Bolts, (2) M8 Lock Washers and (2) M8 Flat Washers, (Fig
1). Do not fully tighten hardware at this time.
STEP 2
Move to the driver side center, center 1 and rear mounting locations.
Repeat Step 1 to install the Driver Center & Center 1 & Rear Mounting
Brackets, (Fig 1).
STEP 3
Once all (4) Driver side mounting brackets are installed, then proceed to
the Step Bar installation. (Figs 2 & 3)
- Select (1) Slider and (2) M8X1.25-35mm Carriage Bolts;
- Install (2) M8X1.25-35mm Carriage Bolts in (1) Slider.
- Slide the Slider (with carriage bolts) to the Step Bar.
- Repeat to install the other (3) sliders to the step bar.
- Attach the Step Bar (with the Sliders) onto the installed mounting brackets. Position the Sliders to the installed brack-ets. Secure the Step Bar to the installed Brackets by using (8) M8 Large Flat Washers and (8) M8 Nylon Lock Nuts and (4) Sliders, (Fig 3). Do not fully tighten hardware at this time.
Note : The Sliders are packed with the Mounting Bracket.
Level and adjust the Step Bar and fully tighten all hardware. Repeat Steps 1-3
for the other side Step Bar installation. The installation is completed!!!
Attention
Do periodic inspections to the installation to make sure that all hardware is
secure and tight.
In order to protect your bars/boards, please use mild soap/non-abrasive
products for cleaning only.
Customer Support: info@iboardauto.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>