Rayrun RM16 RF Wireless LED Remote Controller User Manual
- June 12, 2024
- RayRun
Table of Contents
RF Wireless
LED Remote Controller
Model: RM16
Function
Operation
-
Pair and unpair the remote to receiver
The remote controller needs to be paired to receiver to work. User can pair up to 5 remote controllers to one receiver and each remote controller can be paired to any receiver.
To pair or unpair remote to the receiver, please operate with following steps:
1). Cut off the power of receiver and power on again after more than 5 seconds.
2). Press remote and key simultaneously and briefly within 10 seconds after receiver powered on.
3). To unpair the remote from receiver, do the step 1 first, then press remote and key simultaneously and briefly within 10 seconds after receiver powered on. -
Load and save scenes
User can load or save scenes with 1-4 digit keys. Short press on 1-4 key can load the saved scene.
To save a scene, please adjust the favorite light status first, then hold press 1-4 digit key to save current status to relative scene position. After save operation, user can load the saved scene by short press the digit key. -
Restore the controller to factory default
To restore the paired controller or receiver to factory default mode, please operate with following two steps:
1). Cut off the power of paired controller/receiver and power on again after more than 5 seconds.
2). Press remote and key simultaneously and briefly within 10 seconds after the paired controller/receiver powered on.
After this operation, the paired controller/receiver will be restored to factory settings, and the remote controller will also be unpaired from the controller/receiver.
Specification
Working voltage | DC 3V, CR2032 battery |
---|---|
Frequency band | 433MHz ISM band |
Wireless power | < 7dBm |
Working temperature | -20-55 C(-4-131 F) |
FCC Caution:
Part 15.21
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Part 15.19
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
FCC RF Radiation Exposure Statement:
- This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
- This equipment complies with RF radiation exposure limits set forth for an uncontrolled environment.
- The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Part 15.105
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instr\uctions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>