cecotec 05307 Ready Warm 6000 Ceramic Instruction Manual

June 12, 2024
cecotec

cecotec-LOGO

cecotec 05307 Ready Warm 6000 Ceramic

cecotec-05307-Ready-Warm-6000-Ceramic-PRODUCT

Product Information

The Ready Warm 6000 Ceramic is a ceramic heater designed to provide warmth and comfort in any room. It features a temperature knob, a power knob, and an indicator light for easy operation.
The heater has two heat settings, 750W, and 1500W, and also includes a fan mode for cooling. It is designed with a thermal-overload protector to prevent overheating and has a reset function for safety.

Technical Specifications:

  • Model: Ready Warm 6000 Ceramic
  • SKU: 05307
  • Power: 1500W
  • Voltage: 220-240V
  • Frequency: 50/60Hz

Product Usage Instructions

  1. Before use, ensure that all parts and components are intact.
  2. Connect the heater to a power source.
  3. Set the temperature knob to the desired heat level (0 for off, I for low power, II for high power).
  4. Adjust the power knob to select the desired heat output (- for lower, + for higher).
  5. If the heater reaches extreme temperatures, it will automatically switch off. To reset the heater, unplug it from the power supply and wait for approximately 5-10 minutes. Once cooled down, plug it back in and operate normally.
  6. To use the fan mode for cooling, select the fan option on the temperature knob.
  7. After use, allow the heater to cool down before cleaning.
  8. Clean the heater regularly using a soft cloth. Avoid using abrasive cleaners or solvents.
  9. Refer to the user manual for disposal instructions for old electrical appliances.
  10. If you require technical support or have any warranty-related queries, contact the technical support service provided by Cecotec at +34 963 210 728.

Parts and components

cecotec-05307-Ready-Warm-6000-Ceramic-
FIG-1

  1. Temperature knob
  2. Power knob
  3. Indicator light

SAFETY INSTRUCTIONS

Read these instructions thoroughly before using the appliance. Keep this instruction manual for future reference or new users.

  • Make sure that the mains voltage matches the voltage stated on the rating label of the appliance and that the wall outlet is grounded.
  • Check the power cord regularly for visible damage. If the cord is damaged, it must be replaced by the official Technical Support Service of Cecotec in order to avoid any type of danger.
  • This appliance is for household use only.
  • Do not cover the air inlet or outlet openings while the appliance is operating.
  • Unplug the product while not in use and before cleaning or maintenance.
  • Do not pull from the power cord to unplug or move the product.
  • Avoid the use of an extension cord as this may overheat and cause a risk of fire.
  • Don’t use the product in the immediate surroundings of a bath, a shower or a swimming pool. Keep the heater away from water and other liquids.
  • Keep the product away from flammable materials, surfaces or substances such as curtains or furniture in order to avoid fire hazard.
  • Do not insert any object through the product’s heat outlet or air intake.
  • Remove any flammable materials (e.g., petrol, solvents, spray canisters etc.) or other easy combustible materials (e.g., wood or paper) from the room where the appliance is placed in order to avoid risk of fire.
  • The appliance is not intended to be used by children under the age of 8. It can be used by children over the age of 8, as long as they are given continuous supervision.
  • This appliance can be used by children aged 8 and above, and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge, as long as they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance.
  • Supervise young children to make sure that they do not play with the appliance. Close supervision is necessary when the appliance is being used by or near children.

BEFORE USE

  • WARNING: a slight odour and smoke might appear when heating the device for the first time. This is due to manufacturing materials residues and does not affect the appliance’s operating.
  • Take the product out of its box and remove any packaging materials.
  • Place the heater on a flat surface and away from flammable objects.

OPERATION

SYMBOL FUNCTION

O

| WHEN THE KNOB POINTS 0, THE APPLIANCE WILL TURN OFF
| FAN (WHEN THIS LEVEL IS SELECTED, THE APPLIANCE WILL PRODUCE COLD AIR.)

I

| THE APPLIANCE WILL HEAT AT LOW POWER. (750 W)
II| THE APPLIANCE WILL HEAT AT MÁXIMUM POWER. (1500 W)

  • This heater includes 3 different power levels
  • The temperature can be adjusted from 0 to 40 ºC by turning the temperature knob anticlockwise (-) or clockwise (+).

RESETTING THE HEATER

  • WARNING: the appliance includes a thermal-overload protector to prevent overheating. When the product reaches extreme temperatures, it will automatically switch off and will resume operation only when it is reset.

In order to reset the heater:

  1. Unplug the product from the power supply and wait for 5-10 minutes approx. Allow it to cool down.
  2. Turn the product on again and operate normally.

CLEANING AND MAINTENANCE

  1. Always turn off, unplug and allow the appliance to cool down before cleaning.
  2. Do not use abrasive scouring pads, powders or cleaners to clean the product.
  3. Use a soft, dampened and clean cloth to clean the product’s outer housing.
  4. If the heater is not going to be operated for a long period of time, store it in a dry and safe place where it is protected from dust.

TECHNICAL SPECIFICATIONS

  • Model: Ready Warm 6000 Ceramic
  • Product reference: 05307
  • 1500 W, 220-240 V, 50/60 Hz
  • Made in China | Designed in Spain

DISPOSAL OF OLD ELECTRICAL APPLIANCES

  • The European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE), specifies that old household electrical appliances must not be disposed of with the normal unsorted municipal waste. Old appliances must be collected separately, in order to optimize the recovery and recycling of the materials they contain, and reduce the impact on human health and the environment.
  • The crossed out “wheeled bin” symbol on the product reminds you of your obligation to dispose of the appliance correctly. If the product has a built-in battery or uses batteries, they should be removed from the appliance and disposed of appropriately. Consumers must contact their local authorities or retailer for information concerning the correct disposal of old appliances and/or their batteries.

TECHNICAL SUPPORT SERVICE AND WARRANTY

  • This product is under warranty for 2 years from the date of purchase, as long as the proof of purchase is submitted, the product is in perfect physical condition, and it has been given proper use, as explained in this instruction manual.

The warranty will not cover the following situations:

  • The product has been used for purposes other than those intended for it, misused, beaten, exposed to moisture, immersed in liquid or corrosive substances, as well as any other fault attributable to the customer.
  • The product has been disassembled, modified, or repaired by persons, not authorised by the official Technical Support Service of Cecotec.
  • Faults deriving from the normal wear and tear of its parts, due to use.
  • The warranty service covers every manufacturing defects of your appliance for 2 years, based on current legislation, except consumable parts. In the event of misuse, the warranty will not apply. If at any moment you detect any problem with your product or have any doubt, do not hesitate to contact Cecotec Technical Support Service at +34 963 210 728.

Information required for the electric local space heaters

Model identifier(s): 05307_Ready Warm 6000 Ceramic
Item| Symbol| Value| Unit| Item| Unit
Heat output| Type of heat input, for electric storage local space

heaters only (select one)

Nominal heat output

|

Pnom

|

1.5

|

kW

|

Manual heat charge control, with integrated thermostat

|

No

Minimum heat output (indicative)| Pmin| 0.7| kW| Manual heat charge control with room and/or outdoor temperature feedback| No
Maximum continuous

heat output

| Pmax,c| 1.5| kW| Electronic heat charge control with room and/or

outdoor temperature feedback

| No
Auxiliary electricity consumption| Fan assisted heat output| No
At nominal heat output| elmax| 1.5| kW| Type of heat output/room temperature control (select

one)

At minimum heat output| elmin| 0.7| kW| Single stage heat output and no room temperature

control

| No
In standby mode| elSB| N/A| kW| Two or more manual stages, no room temperature

control

| No
 |  |  |  | With mechanic thermostat room temperature

control

| Yes
 |  |  |  | With electronic room temperature control| No
 |  |  |  | Electronic room temperature control plus day timer| No
 |  |  |  | Electronic room temperature control plus week

timer

| No
 |  |  |  | Other control options (multiple selections possible)
 |  |  |  | Room temperature control, with presence detection| No
 |  |  |  | Room temperature control, with open window

detection

| No
 |  |  |  | With distance control option| No
 |  |  |  | With adaptive start control| No
 |  |  |  | With working time limitation| No
 |  |  |  | With black bulb sensor| No
Contact details: Grupo Cecotec Innovaciones S.L. · C/de la Pinadeta s/n 46930 Quart de Poblet, Valencia (SPAIN)

www.cecotec.es

Documents / Resources

| cecotec 05307 Ready Warm 6000 Ceramic [pdf] Instruction Manual
05307 Ready Warm 6000 Ceramic, 05307, Ready Warm 6000 Ceramic, Warm 6000 Ceramic, 6000 Ceramic, Ceramic
---|---

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

cecotec User Manuals

Related Manuals