OzSpy AF-MQU350 Voice Recorder User Guide
- June 12, 2024
- OzSpy
Table of Contents
OzSpy AF-MQU350 Voice Recorder User Guide
Initial Setup
Charging: Connect the device to a USB power outlet. While the device is charging the LED flashes. Once the device is fully charged the LED will stay on. Prior to first use only, please ignore the LED indicator and continue to charge the device for an additional 4 hours. This device will record while charging for continuous operation.
Time Setup: Connect the device to a computer. Run the ‘Time Setup’ file. Set the Record Quality, SVOS Level (-2 will respond to loud sound; +2 respond to low sound) and select Start. The date and time will be set according to you computers current settings.
Audio Recording and Playback
Continuous Record Mode: Turn the recording switch in an upwards direction. Recording will start in about 5 seconds and continue to record until either the battery runs flat (approx 24 hours from full charge); the storage is full (8gb) or the switch is returned to the centre off position.
Voice Activation Mode (SVOS): Turn the recording switch in a downwards direction. Recording will start in about 5 seconds. If no sound is detected the device will enter standby mode after approx 1 minute and reactivate when sound is detected. Recordings will continue until either the battery runs flat (approx 24 hours recording time from full charge); the storage is full (8gb) or the recording switch is returned to the centre off position. Battery life in standby mode is approximately 25 days.
Playback: Make sure the recording switch is returned to the centre off position. Connect the device to a computer or any Media Player that supports USB and MP3 playback.
Battery Life Remaining: When recording is started the LED displayed for first 5 seconds will indicate the battery life. Off = less than 30%; Flashing = 30-70%; On = more than 70%.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>