Alpha L36P Smart Portable Projector User Manual

Smart Portable Projector
L36P
V1.01
User Manual

REMOTE CONTROL

Do not submerge the remote control in water.
Do not put the remote control near a fire or ina wet/hot place.
Do not use old and new batteries together in the remote control.
Please take the batteries out if not using the remote control for along time to avoid battery leakage.
Please point the remote control at the IR receiver.
Please use the remote control within 6 meters distance and 30 degree angle.

INTERFACES & QUICKSTART

CONNECT TOABLUETOOTH SPEAKER

1. Select the “BT” in the HOME main menu first.

2. Press “ok” key to turn Bluetooth on

3. Select “Search” and press “OK” to scan nearby Bluetooth speakers.

4. Select your Bluetooth speaker from the list, press Ok key to connect (pair)
   ‘o’. Tips:
   When power on the projector or turn on Bluetooth, the projector attempts toconnect the latest connected Bluetooth speaker.

SCREEN MIRRORING

“Important: Before screen mirroring, please select “Screen Mirroring’ in the HOME main menu first.

For ios System

For iOS devices, there are two ways to connect as follows.
*Method A Streaming with Your router’s WiFi

1. Turn on the projector, select “Screen Mirroring” in the HOME main menu and then choose “i0S Screen’
2. Press “OK” on the remote or projector to connect your Router’s WiFi.
3. Turn on the WLAN of your iOS device and connect to the same Router’s WiFi above.
4. Then go to the “Screen Mirroring” of the ioS device and select “L36P-XXXXXX” to connect.
5. The screen miroring connection success.

Announcements

1. No Sound
   * Externalspeaker is required for VGA cable connection.

2. Blurry Image

• Adjust the focus ring/keystone.
• The projector and the screen/wall must be with in effective distance. 3. Remote Unresponsive
• Make sure the remote points at thelR receiver directly.
• Do not coverlR receiver. 4. Mobile Connection
  iOS: Genuine lightning to HDMI cable
  Android: Micro USB to HDMI adapter/Type C to HDMI cable

FCC warning statements:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause  undesired operation.
The device has been evaluated to meet general RF exposure requirement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>