FALCON RIDGE PO-150-WD01 Half Polycarbonate Windshield Instruction Manual
- June 3, 2024
- FALCON RIDGE
Table of Contents
2515 Bypass Rd. Flemingsburg, KY
41041606-845-7439
Instructions for Installation and Care of
Polaris Ranger 150
Half Polycarbonate Windshield
PO-150-WD01
PO-150-WD01 Half Polycarbonate Windshield
- Be sure to read these instructions thoroughly before opening and installing the Polaris Ranger 150 Half Polycarbonate Windshield.
- Check over the parts included in the cartons with the parts list shown below:
Strap Clamps| 2 each
---|---
43” Side Bulb Gasket| 1 each
Windshield| 1 each - Start by pulling it out of the box and find a clean area to lay it down and install the hardware. Begin by peeling off the protective film. Next, take the 40” piece of rubber gasket and starting at one end firmly place it across the bottom of the windshield. You may need to trim any excess.
- You are now ready to install the windshield on your roll cage. Place the windshield on the vehicle first. Then take the two Velcro clamps and place them through the square holes then wrap the strap around the roll cage and under the wire as shown in the photo below.
- Then just Pull the strap back around the bar and attach it to the Velcro.
- Now you are ready to take it out and enjoy. To clean the windshield, always clean using a liquid of some sort to decrease the chance of scratches. We recommend using microfiber cloths that are readily available at any dollar store. Any window cleaner will work fine; just remember to use a soft clean rag or micro-fiber cloth to clean it.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>