OMIX-ADA 11585.02 Spare Tire Spacer Instruction Manual
- June 13, 2024
- OMIX-ADA
Table of Contents
Spare Tire Spacer
Components:
| 1. Body Mount | (1) |
|---|---|
| 2. Wheel Mount | (1) |
| 3. Flat Washer | (5) |
| 4. Lock Washer | (6) |
| 5. Locking Hex Nut | (2) |
| 6. M12 x 1.25 x 35 Hex Bolt | (3) |
| 7. M12 x 1 x 30 Hex Bolt | (2) |
| 8. M12 Hex Nuts | (3) |
| 9. 1/2-20 Hex Nuts | (3) |
| 10. M12 x 1.25 Lug Nuts | (3) |
-
Remove spare tire. Install Body Mount using Flat Washers and Lock Washers. Depending on factory stud sizes use either M12 Hex Nuts, or 1/2” Hex Nuts to attach Body Mount to vehicle.
NOTE: M12 Nuts will install on on 1/2 factory stud, but will NOT be secure. 1/2” Nuts will NOT install on M12 factory stud.
Read all instructions thoroughly before installation. -
Attach Wheel Mount to Body Mount using M12 x 30 Hex Bolts, Flat Washers, and M12 Lock Nuts.
Mount is slotted to allow side-to-side adjustment. Set side-to-side position and tighten Lock Nuts.
-
Use diagram below to determine proper bolt pattern for your vehicle. Install M12 x 35 Hex Bolts and Lock Washers into your bolt pattern.
-
Install spare tire onto bolts using provided Lug Nuts. Tighten Lug Nuts to secure spare tire.
Make sure all bolts and nuts are fastened tightly.
| Bolt Pattern | Holes to use |
|---|---|
| 5” x 4.5” | A |
| 5” x 5” | B |
| 5” x 5.5” | C |
Rev 17/2022
Copyright © 2013 Omix-Ada®, Inc.
OMIX-ADA® TECHNICAL SUPPORT
PHONE: M-F 8am – 5pm EST 1-800-449-6649
| EMAIL: techsupport@omix-ada.com
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
11585.02
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024
PHONE: 770-614-6101
FAX: 770-614-6069
info@omix-ada.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>