Omix-Ada 11210.11 Aluminum Hood Catch Instruction Manual
- June 13, 2024
- OMIX-ADA
Table of Contents
Omix-Ada 11210.11 Aluminum Hood Catch Instruction Manual
Contents:
- A – Latch
- B – Latch Joint
- C – Pivot Base Joint
- D – Pivot Base
- E – Catch
- F – Pivot Base Gasket
- G – Catch Gasket
- H – Flat Head Bolts
- I – Lock Nuts
- J – Binding Posts
- K – Jam Nuts
- L – Adjustment Rod
- M – Safety Snap
Suggested Tools:
- Basic Hand Tools
OMIX-ADA® TECHNICAL SUPPORT PHONE: M-F 8am – 5pm EST
1-800-449-6649 | EMAIL: techsupport
@omix-ada.com
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
460 Horizon Drive #400 | Suwanee, GA 30024 USA | www.omix-ada.com | Copyright © 2013 Omix-Ada®, Inc.
-
Remove the factory hood catch.
-
Pull/remove the hood bumper from the factory hood catch.
-
Remove the pivot base from the Aluminum Hood Catch assembly.
-
Attach the hood bumper (Removed in Step 2) to the pivot base.
-
Fasten the catch to the hood. Fasten the pivot base to the fender.
NOTICE Be sure safety snap is securely attached to catch. -
Re-attach the Aluminum Hood Catch assembly to the pivot base using the binding posts removed in Step 3.
-
Adjust the Aluminum Hood Catch by first releasing the latch. With jam nuts loose, rotate latch clockwise to increase tension or counter clockwise to decrease tension. When adjusted properly, hood should contact and slightly compress the hood bumper.
NOTICE Be sure adjustment rod has thread engagement equal or greater to 3 threads on each end. Operating vehicle with inadequate thread engagement could result in damage to vehicle. -
Your Aluminum Hood Catch is installed and road ready!
460 Horizon Drive #400 | Suwanee, GA 30024 USA | www.omix-ada.com | Copyright © 2013 Omix-Ada®, Inc.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>