Omix-Ada 11025.11 Quick Release-Stubby Trail Mirror Round User Guide
- June 13, 2024
- OMIX-ADA
Table of Contents
Omix-Ada 11025.11 Quick Release-Stubby Trail Mirror Round
Product Information
| Part Number | 11025.10 | 11025.11 | 11025.19 | 11025.21 |
|---|---|---|---|---|
| Product Name | Quick Release/Stubby Trail Mirror, Round | |||
| Components | Mounting Bracket | Thumb Screw | Bushing | M8 Bolt, Arm, Mirror |
| Manufacturer | Omix-Ada | |||
| Address | 460 Horizon Dr. Suite 100, Suwanee, GA 30024 | |||
| Phone | 770-614-6101 | |||
| Fax | 770-614-6069 | |||
| info@omix-ada.com |
Product Usage Instructions
- For JK (07-17): Using T40 Torx Wrench, remove two upper windshield bracket bolts. For TJ (96-06): Using T40 Torx Wrench, remove two flush mount torx head bolts just in front of door hinge.
- Using the supplied hardware, install the Mounting Bracket with the welded nut facing down.
- Attach the Arm to the Bushing. Using the Thumb Screw, loosely install the Bushing and Arm into the Mounting Bracket.
- Attach the Mirror to the flat side of the Arm using the Mirror’s hardware. Tighten the screws on the back of the Mirror. The Mirror should be tightened but able to be adjusted if needed.
- WARNING: For TJs (97-06), it is recommended to use quick release mirrors without doors on the vehicle.
- When doors are reinstalled, remove the Arm from the bracket. Place the Bushings back into the Mounting Bracket and tighten the Thumb Screw.
Components
- Mounting Bracket
- Thumb Screw
- Bushing
- M8 Bolt
- Arm
- Mirror
INSTALLATION INSTRUCTION
-
For JK (07-17): Using T40, Torx Wrench, remove two upper windshield bracket bolts. For TJ (96-06): Using T40 Torx Wrench, remove two flush mount torx head bolts just in front of door hinge.
-
Using supplied hardware, install Mounting Bracket with welded nut facing down.
-
Attach Arm to Bushing. Using Thumb Screw, loosely install Bushing and Arm into Mounting Bracket.
-
Attach Mirror to flat side of MArm using Mirror’s hardware. Tighten screws on the back of the Mirror. Mirror should be tightened but able to be adjusted if needed.
WARNING: For TJs (97-06), it is recommended to use quick-release mirrors without doors on vehicle. -
When doors are reinstalled remove Arm from bracket. Place Bushings back into Mounting Bracket and tighten Thumb Screw.
Copyright © 2016 Omix-Ada®, Inc.
OMIX-ADA® TECHNICAL SUPPORT
PHONE: M-F 8am – 5pm EST
1-800-449-6649 | EMAIL:
techsupport@omix-ada.com
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
460 HORIZON DR. SUITE 100 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | info@omix- ada.com