COMMSCOPE F1A-XMPNF-M5 HELIAX Jumper Products Push Pull Connector Installation Guide
- June 13, 2024
- CommScope
Table of Contents
**COMMSCOPE F1A-XMPNF-M5 HELIAX Jumper Products Push Pull Connector Installation Guide
**
Maintain 2-inch straight cable length behind the cable.
Do not hold the connector and bend the cable directly behind it, rather hold
the cable adjacent to the connector to keep stress from the cable/connector
junction.
Do not exceed the cable minimum bend radius.
**Single Bend Radius Table***
Cable| Radius, inches
FSJ1| 1.0 (25.4mm)
FSJ2| 1.0 (25.4mm)
LSF2| 1.0 (25.4mm)
*Note: Requires use of mandrel to achieve single bend radius.
Route and form the cable in place prior to attaching the coupling nuts
Do not twist the cable into position.
Do not attach the connector coupling nut of one jumper connector and leave the opposite end hanging unattached.
Assemble: Hold the connector body and push it onto the female interface.
Listen for a click sound to fully engage
Disassemble: Hold the connector body stationary and pull back the
coupling nut to disengage. DO NOT pull back the connector body and cable.
NOTE: Connector interface threads and O-rings are designed for mate ability without ANY supplementary treatment to threads or O-rings. If any type of supplementary lubricants/oils are used, the warranty will be void, and connector/assembly performance may be affected.
Comm Scope
1100 Comm Scope Place SE P.O. Box 339, Hickory, NC 28603-0339
828-324-2200
800-982-1708
www.commscope.com
Customer Service 24 hours
North America: +1-800-255-1479
(toll free)
Any country: +1-779-435-6500
email:
acicustomersupportcenter@commscope.com
Notice: Comm Scope disclaims any liability or responsibility for the results of improper or unsafe installation, inspection, maintenance, or removal practices.
© March, 2019 CommScope
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>