EBECO Snowmat Heating Cable Mat Instruction Manual

: June 13, 2024
: EBECO

Table of Contents

Snowmat Heating Cable Mat
Welcome
Important
Technical specifications
Before you start
Installing the Ebeco Snowmat
Terms of Warranty
Test report
Documents / Resources

Snowmat Heating Cable Mat
Instruction Manual

Snowmat Heating Cable Mat

EBECO Snowmat Heating Cable Mat Snowmat
INSTALLATION INSTRUCTIONS

Skapa garantibevis direkt i mobilen garantera.ebeco.se

Welcome

Thank you for choosing Ebeco. For the warranty to be valid, the product must be installed and handled as indicated in this manual. It is therefore important that you read the manual.
If you have any questions, please contact us at Ebeco. Call +46 31-707 75 50 or send an e-mail to info@ebeco.se. Feel free to visit ebeco.com for more information.

Important

The system is a high voltage system and must thus be installed according to applicable regulations and under the supervision of an authorised electrician. For the warranty to apply, the guarantee certificate must be correctly and completely filled in, and signed by an authorised electrician.

Technical specifications

Art.nr| Power| Width| Length| Area| Resstance| Insulation
---|---|---|---|---|---|---
8960301| 660 W| 0,5 m| 4,4 m| 2,2 m²| 80,6 Ω| > 10 MΩ
8960303| 1060 W| 0,5 m| 7,0 m| 3,5 m²| 49,8 Ω| > 10 MΩ
8960305| 1320 W| 0,5 m| 8,8 m| 4,4 m²| 40,2 Ω| > 10 MΩ
8960307| 2250 W| 0,5 m| 15,0 m| 7,5 m²| 23,6 Ω| > 10 MΩ
8960309| 2785 W| 0,5 m| 18,7 m| 9,35 m²| 19,0 Ω| > 10 MΩ
8960311| 3390 W| 0,5 m| 22,6 m| 11,3 m²| 15,6 Ω| > 10 MΩ

Tolerance ± 10 %

Before you start

Check that the material supplied corresponds with the information on the delivery note.
Measure the insulation and resistance of the mat. See values in the table. Enter the values in the test report (at the end of the manual).
The insulation and resistance of the mat must be measured before and after embedding/surfacing, to check that the mat was not damaged when it was laid. Enter the values in the test report.
After being placed in the bed of sand, the mat can be covered with ground slabs, paving stones or asphalt. (NOTE: Do not lay in hot asphalt). The mat can also be laid above existing concrete slabs and embedded.
We recommend that you use the Ebeco Quick Board (8960150) for a more energy efficient installation.
When planning the installation, take into account the fact that the length of the cold cable is 5 m.
The cold cable splice must be laid in sand/concrete. The heating cable must not be cut. Only the cold cable may be shortened.
The cable must not touch or cross itself. Minimum distance 60 mm.
The cable must not cross any expansion joints.
Plan how any control sensors are to be positioned. Measuring elements for thermostatic control are to be laid in a plastic tube under the mat. Panelboard with temperature/humidity sensor: refer to the instructions supplied with the panelboard.
Fill in and affix the heating cable signs for each junction box. A diagram/photo of the heating mat installation must be on display in the electrical distribution centre.

Installing the Ebeco Snowmat

The installation is described using illustrations. See page 10.

Terms of Warranty

Snowmelt, Snowmat, MI-60 and Multiflex 27*

Ebeco AB provides a 10 year guarantee for defective materials in Snowmelt, Snowmat, MI-60 and Multiflex 27. The guarantee only becomes valid under condition that the installation is carried out by a authorized electrician according to the applicable regulations and in accordance with installation instructions issued by Ebeco. This guarantee certificate, including the test record below, must be completed in its entirety and, along with the materials specification or invoice, must be signed by the electrician who
carried out the installation.
Furthermore, there must be photographs/ sketches that show the mat in its entirety after laying but before covering. If defects should arise during the guarantee period, Ebeco AB undertakes to repair or alternatively replace Snowmelt/ Snowmat/Multiflex at no cost to the purchaser.
Ebeco AB also undertakes to restore the surface coating to its original condition after the repair or replacement has been completed. In order to be able to remedy the fault, the purchaser must have saved or have access to 1 m² of the existing surface material.
For any controls (timer/panelboard), where defects occur after 3 years, Ebeco AB will supply a new control. The guarantee does not apply to installations that have been carried out by an non authorized electrician or alternatively if an non authorized electrician has carried out modifications or repairs. Nor does the guarantee apply if the defect has arisen as a result of using incorrect materials and construction or as a result of incorrect installation. Nor is damage covered that is a result of vandalism, fire, lightning, water damage or damage caused by negligence, abnormal usage or as a result of an accident.
In the event of a material defect that is covered by the guarantee Ebeco AB must be notified.
In the event of the guarantee being invoked, this guarantee certificate with accompanying invoice of installation, material specification plus completed and signed test record must be presented.
EBECO AB
Martin Larsson, CEO

Extended warranty only applies provided that the product has been installed together with Ebeco’s control system.

Test report

(Snowmelt, Snowmat, MI-60 and Multiflex 27)

| Before laying| After fixing| After surface coating/ embedding
---|---|---|---
Mat/Cable no. 1-6| Resistance value| Insulation value| Resistance value| Insulation value| Resistance value| Insulation value
No. 1, E-no: …………..| | | | | |
No. 2, E-no: ………….| | | | | |
No. 3, E-no: ………….| | | | | |
No. 4, E-no: ………….| | | | | |
No. 5, E-no: ………….| | | | | |
No. 6, E-no: ………….| | | | | |

Min. insulation value 10 MΩ.

The system is documented with photos/drawings

Electrical installation carried out by: ……………………………………………………………………….
Date: ……………………………………………………………….
Signature: ………………………………………………………… according to the attached materials specification. EBECO Snowmat Heating Cable Mat - Fig 1 EBECO
Snowmat Heating Cable Mat - Fig 2