COMMSCOPE SFG23RHDXL Sector Frame Long Spine Installation Guide
- June 1, 2024
- CommScope
Table of Contents
COMMSCOPE SFG23RHDXL Sector Frame Long Spine
Specifications
- Model: SFG23RHDXL15-5-126
- Dimensions: Height: 126 inches, Length: 180 inches, Width: 120 inches
- Material: Steel
- Finish: Not specified
- Weight: 1188.63 lbs
- Volume: 4191.37 cubic inches
- Surface Area: 36280.84 square inches
Product Usage Instructions
General Notes
- Ensure all metric dimensions are converted to inches before proceeding with installation.
- For patent information, refer to https://www.cs-pat.com.
Design Notes
- Prior to installation, identify any hazards or obstructions that may affect the climbing facility and safety climb. Additional products might be needed to maintain safety.
- During installation, take temporary and/or permanent precautionary measures to protect the climbing facility and safety climb.
Installation
Tighten all bolts securing flat plates using the turn-of-nut method. Ensure
equal distance and force on each leg of the U-bolt when tightening.
Testing
After installation, perform a thorough test to ensure the structural
integrity of the product.
Packaging
The packaging must meet CommScope requirements as per document IS-PL-3005.
Printed documents should be placed inside a polybag before being placed in the
shipping container. Extra hardware may be supplied separately.
Frequently Asked Questions (FAQ)
-
Are all necessary components included in the package?
Yes, all required components for assembly are provided in the kit. Individual parts are included within the package. -
What is the recommended method for tightening U-bolts?
Use the turn-of-nut method to tighten U-bolts, ensuring equal distance and force on each leg of the U-bolt.
NOTE
-
GENERAL NOTES
-
ALL METRIC DIMENSIONS ARE IN BRACKETS [X.X]
-
FOR PATENT INFO: https://www.cs-pat.com
-
DESIGN NOTES
-
ANY HAZARDS OR OBSTRUCTIONS TO THE CLIMBING FACILITY AND SAFETY CLIMB MUST BE IDENTIFIED PRIOR TO INSTALLING THE APPURTENANCE. ADDITIONAL PRODUCTS MAY BE REQUIRED TO MAINTAIN THE INTEGRITY OF THE SAFETY CLIMB. DURING INSTALLATION, TEMPORARY AND/OR PERMANENT PRECAUTIONARY MEASURES SHOULD BE TAKEN TO PRESERVE THE CLIMBING FACILITY AND/OR SAFETY CLIMB.
-
UP TO 5.0° TAPER AVAILABLE ON MODELS THAT SUPPORT ADJUSTMENT
-
MANUFACTURING/SPECIAL REQUIREMENTS
TIGHTEN ALL BOLTS SECURING FLAT PLATES BY THE TURN-OF-NUT METHOD. TIGHTEN ALL U-BOLTS USING TURN-OF-NUT METHOD WITH ATTENTION TO LEAVE EQUAL DISTANCE AND EQUAL FORCE ON EACH LEG OF THE U-BOLT. -
TEST
-
PACKAGING
-
PACKAGING SHALL MEET COMMSCOPE REQUIREMENTS PER DOCUMENT IS-PL-3005.
-
PRINTED DOCUMENT TO BE PLACED INSIDE POLYBAG AND THEN IN SHIPPING CONTAINER.
-
EXTRA HARDWARE MAYBE SUPPLIED, BAGGED AND SHIPPED.
SPECIFICATION
PRODUCT OVERVIEW
DIMENSION
ACCESSORIES ORDERED SEPARATELY
