SpeedyBee Master 5 V2 Air Unit FPV 5 Freestyle Frame Installation Guide

SpeedyBee Master 5 V2 Air Unit FPV 5 Freestyle Frame

Installation Instructions

• (Note: 3D e昀昀ect requirements, the actual object shall prevail)

CNC camera mount and camera side plate installation

• Install the front top plate
  

• Antenna Installation Sequence

• Insert the O-ring into the antenna to secure it on the TPU antenna base.
  

Install the multi-function antenna base

1. Install the plate on one side and GPS base

2. Install the T-shaped antenna
   

3. Choose a suitable VTX antenna base

4. Choose a suitable VTX antenna base
   *(Note:** pictures for assembly reference only. Frame doesn’t include antenna)
   

Install arms and anti-vibration module

*Notice: front and back arms

• Front arm
  

• Back arm
  

(Complete the installation of 4 arms in turn)

❶ Screws pass through the bottom plate and the intersection position of the arms in turn.

Install middle plate

❶ Install the middle plate to the corresponding 6 screw positions.

❷ Tighten the two press-in nuts where the arms intersect.

Combination with completed parts 1 and 2

❶  Combination of frame and CNC camera mount.

❷  Install 7075 standoff

❹  Frame and antenna base combination.

Install rear top plate and battery anti-slip silicone

❶  Finally, install the rear top plate and battery anti-slip silicone.

Arm foot mount installation

❶ Install the 3D printed foot mount to arms

❷ Use screw of proper length based on the motor installation.

*(Notice: default screws are M38mm, M310mm)**

O3 Air Unit Installation Method

• Pass through the top of the VTX
  

• The 4 original screws at the bottom of the O3 Air Unit need to be removed

Recommend installing ESC in reverse horizontally 180°

*Note (After the ESC is installed reversely, remember to rede昀椀ne the correct position and direction of motors 1-4.)

It is recommended to keep the power cable of ESC to be about 100mm. Please refer to the used batte爀礀 for actual length.

ESC power cable soldering and recommended length for cable of motor

*Note: connect buzzer with mark to BZ+ of light controller, and buzzer without mark to BZ

• Inner motor wire recommended length: 110mm
  

• Outer motor wire recommended length: 93mm
  

Scale

Customer Support

Scan the QR code to get the installation guide. We recommend you scan it through the Speedy Bee App for detailed instructions.

Speedy Bee APP

Installation Guide

Facebook QR Code

Documents / Resources

| SpeedyBee Master 5 V2 Air Unit FPV 5 Freestyle Frame [pdf] Installation Guide
20230814-5-V2, Master 5 V2 Air Unit FPV 5 Freestyle Frame, Master 5 V2, Air Unit FPV 5 Freestyle Frame, Unit FPV 5 Freestyle Frame, FPV 5 Freestyle Frame, Freestyle Frame, Frame
---|---

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>